Advertisement

Advertisement

Driving -> Anti-intrusion alarm for Your Citroen C5 Suv First Generation (2001-2008)

ANTI-INTRUsION ALARM  
Deactivation of the alarm  
usng the remote control  
B
The alarm is disarmed when you  
unlock the vehicle (with a press on  
button B on the remote control).  
ii  
a
Deactivation of the alarm  
with the key  
Unlock the doors with the key. The  
siren triggers. enter the vehicle,  
insert the key in the ignition and  
turn it to the drive position to stop  
the siren. Otherwise the siren will  
continue for approximately 30 sec-  
onds.  
The installation also has a siren,  
and a warning lamp on the con-  
trol a which is visible from outside  
the vehicle, indicating the three  
possible statuses of the alarm.  
The anti-intrusion alarm provides:  
exterior perimeter protection by  
means of detectors on the vehicle  
access points (doors, boot, bon-  
net).  
Alarm not active (disarmed),  
warning lamp off.  
Alarm active (armed), the warn-  
ing lamp flashes slowly.  
Alarm triggered (signalling an  
intrusion), the warning lamp  
flashes rapidly if the alarm is  
deactivated by a press on the  
control B. It stops as soon as  
you switch on the ignition.  
electrical supply protection.  
Interior volumetric protection  
by means of ultrasonic sensors  
(detecting movement inside the  
passenger compartment). This  
can be deactivated using the con-  
trol a.  
Anti-lifting protection by means of  
sensors.  
Note: If there is a malfunction,  
the warning lamp remains perma-  
nently on.  
25  
ANTI-INTRUsION ALARM  
Deactivating the volumetric  
detection  
C
B
you can operate the alarm with  
perimeter protection only, by deac-  
tivating the volumetric protection (if  
for example you wish to leave an  
animal in the vehicle).  
ii  
a
Deactivation of the  
volumetric detection  
switch off the ignition.  
Within ꢀ0 seconds, press button a  
until the warning lamp remains on  
permanently.  
exit the vehicle.  
Lock or deadlock the vehicle with  
the remote control locking button.  
The siren is also triggered if there  
is a cutting of the electrical sup-  
ply. To stop it, restore the electrical  
supply then press on the unlocking  
button B.  
Operating the alarm  
First make sure all the doors are  
closed.  
The alarm is armed by pressing  
button C on the remote control.  
The light on button a flashes once  
a second.  
Note:  
With the alarm armed, the protec-  
tions are active after 5 seconds  
(perimeter) and 45 seconds (volu-  
metric).  
When the alarm is armed (on  
standby), any intrusion will trigger  
the siren for 30 seconds, accom-  
panied by the direction indicators  
lighting up.  
The alarm then goes back on  
standby. The triggering remains  
memorised. The warning lamp on  
button a flashes quickly when the  
alarm is deactivated by pressing  
the unlocking button B. This flash-  
ing stops when you switch on the  
ignition.  
Note: It is recommended to deacti-  
vate the volumetric detection when  
washing the vehicle in order to pre-  
vent the random triggering of the  
alarm.  
If you want to lock your vehicle  
without arming the alarm, just  
lock with the key only.  
If you lock your vehicle and a  
door, or the boot, is still open,  
the central locking does not  
operate but the alarm will arm  
itself after approx. 45 seconds.  
automatic activation  
(depending on country)  
The alarm is armed automatically,  
ꢁ minutes after the last door, or the  
boot, has been closed.  
In order to prevent the alarm from  
triggering when you open one of  
the doors or the boot, it is essen-  
tial to press the unlocking button B  
again on the remote control.  
Note: The siren is automatically  
deactivated (for example for dis-  
connecting the battery) as soon as  
the vehicle is unlocked using the  
remote control.  
26