Mirrors and windows
Reinitialisation
Following reconnection of the battery,
the safety anti-pinch function must be
reinitialised.
Lower the window fully, then raise it, it will
rise in steps of a few centimetres each time
the control is pressed. Repeat the operation
until the window is fully closed.
Continue to press the control for at least one
second after the window closed position has
been reached.
The electrical functions of the electric
windows are deactivated:
ELECTRIC WINDOWS
The safety anti-pinch does not operate
during these operations.
1. Driver's electric window control
2. Passenger electric window control
-
approximately 45 seconds after the
ignition is switched off,
Good practice
-
after one of the front doors is opened,
if the ignition is off.
There are two operating modes:
If the electric windows meet an obstacle
during operation, you must reverse the
movement of the window. To do this, press
the control concerned.
Safety anti-pinch
Manual mode
If your vehicle is fitted with the safety anti-
pinch function, when the window rises and
meets an obstacle, it stops and partially
lowers.
Press or pull the control, without passing the
point of resistance. The window stops when
you release the control.
When the driver operates the passenger
electric window controls, he must ensure
that no one is preventing correct closing of
the windows.
In the event of unwanted opening of the
window on closing, press the control until
the window is fully open. Within the next
4 seconds, pull the control until the window
is fully closed.
Automatic mode
The driver must ensure that the passengers
use the electric windows correctly.
Press or pull the control, beyond the point
of resistance. The window opens or closes
fully when the control is released. Pressing
the control again stops the movement of
the window.
Be aware of children when operating
the windows.
The safety auto-reverse does not operate
during these operations.
English 