Advertisement

Advertisement

EASE OF USE and COMFORT -> Practical information for Your Citroen Dispatch Van First Generation (1994-2006)

Practical information  
Glove box  
Storage compartment  
PRACTICAL INFORMATION  
CAB FITTINGS  
This is fitted with a lock, you can lock it  
using the key.  
It contains three sockets for the connection  
of portable electronic equipment (video  
equipment, ...) if the vehicle is fitted with a  
colour screen.  
Depending on the vehicle's equipment, the  
various fittings below enhance your cab.  
Sun visor  
It also contains cup holders and  
compartments for storing maps, a packet of  
cigarettes, an A4 format document, a pen, etc.  
To prevent dazzle from ahead, fold the sun  
visor down.  
A pocket is provided in the driver's sun visor  
for storing toll cards, tickets, ...  
Practical information  
Ashtray  
Storage tray and bottle holder (1.5 L) Ticket storage  
Any liquid carried in an open receptacle  
(cup or other) may be spilt, with the risk  
of damage to switches and controls at  
the driving position and centre console.  
"Take care".  
According to the configuration of the vehicle.  
12 volt socket  
The maximum power of the socket, which is  
of the cigarette lighter type, is 120 W.  
3
Practical information  
Overhead storage unit  
This is located above the sun visors and  
has two compartments for storing a jumper,  
a file, ...  
Tip: the central cavity of the overhead  
storage unit, located in the extension of the  
vehicle's roof between the rear space and  
the cab, allows long objects to be carried.  
Take care to support and wedge them  
securely.  
Be aware that storing a hard object in direct  
contact with the compartment may result  
in noise.  
The tunnel may be added to by an internal  
rack, offered as an accessory.  
For raised vehicles, a shelf located above  
the overhead storage unit can be used to  
store small objects and materials (straps,  
cloths, gloves, helmets, etc...).  
Practical information  
Front courtesy lamp  
Rear courtesy lamp  
Cab: comes on when one of the  
Front individual reading lamps  
These are switched on and off by  
means of a manual switch, with the  
ignition on.  
COURTESY LAMPS  
front doors is opened.  
Automatic operation  
The front courtesy lamp comes on when  
the key is removed from the ignition, when  
the vehicle is unlocked, when one of the  
front doors is opened and for location of the  
vehicle using the remote control.  
Areas for toll cards / car park tickets  
Load space: comes on when one  
of the rear doors is opened.  
The athermic windscreen has two non-  
reflective zones located either side of the  
base of the interior mirror.  
If the doors remain open for a few  
minutes, the courtesy lamps go off.  
They are intended for affixing toll cards and/  
or car park tickets.  
It goes off gradually after the ignition is  
switched on and when the vehicle is locked.  
Permanently on, ignition on.  
Permanently off.  
3
Practical information  
Head rests and seat belts  
Rear side glasses  
CREW CAB  
Bench seat  
Each seat has a head rest adjustable for  
height and angle.  
If fitted to your vehicle, the side glasses can  
be opened.  
The three seats are equipped with inertia  
reel seat belts. The seat belts are integral  
with the backrest of the bench seat.  
Squeeze the two controls together then slide  
the window. There are 4 position notches.  
The crew cab consists of a 3-seat bench,  
located in row 2, the one-piece back of  
which is fixed to the "load retainer" glazed  
partition.  
When driving, the glass should be closed or  
secured at one of the 4 notches.  
Ensure that the seat belt is attached to the  
correct buckle.  
Access to the rear seats is via the sliding  
side door.  
For more information on the use of this  
equipment, refer to "Seat belts" in section 4.  
Good practice  
The rear seat belt stalks are not designed for securing the load transported. Use the lashing rings on the floor only.  
The bench seat of the crew cab is not suitable for the installation of a child seat.  
Practical information  
LOAD SPACE FITTINGS  
Depending on the vehicle's equipment, the  
various fittings below enhance your load  
space.  
Lashing rings  
Locations for lashing rails  
Use the lashing rings on the rear floor to  
secure your loads.  
Locations for fitting a lashing rail are  
available on each side of the vehicle.  
As a safety precaution in case of sharp  
braking, you are advised to place heavy  
objects as far forwards towards the cab as  
possible.  
Trims  
The lower parts of the sides are fitted with  
load protection trims.  
You are advised to immobilise the load by  
securing it firmly using the lashing rings on  
the floor.  
Roof box on raised version  
This is a storage compartment located in the  
load space, above the cab roof.  
3
Practical information  
12 volt socket  
Load retainer  
Ladder type vertical separation or  
partition  
This operates with the ignition on.  
Maximum power: 120 W.  
On the floor, behind the front seats, a  
horizontal partition protects the driver and  
front passengers against the risk of load  
movement.  
Behind the driver's seat, a ladder type  
vertical separation or partition protects the  
driver against the risk of load movement.  
Panel or glazed separation partitions permit  
separation of the load space from the cab.