Get Infotainment system -> General instructions for use Guide for Cupra Formentor SUV First Generation (2020-2024)

Introduction

●

If a function button is missing on the

In some countries, the infotainment sys-

General instructions for use

screen, it is not a device defect, but corre-

sponds to the specific equipment of the

country or version.

tem automatically shuts off when the engine

is switched off and the vehicle's 12-volt bat-

tery charge level is low.

Operating indications

●

Some infotainment functions can only be

On vehicles with park assist, the audio

●

The infotainment needs a few seconds for

selected when the vehicle is at a standstill. In

some countries the parking lock must also

be enabled (button P ) or the selector con-

trol must be in the neutral position N. This is

not a malfunction, but is due to compliance

with legislation.

source volume is automatically lowered

when reverse gear is selected. The volume

reduction can be adjusted.

the complete start-up of the system and

during that time it does not react to inputs.

Only the image of the rear view camera sys-

tem can be displayed during system start-up.

●

Information about the included software

and the license conditions can be found in

Settings > Copyright.

●

The display of all indications and the exe-

cution of functions only takes place once the

infotainment system has finished booting.

The duration of the system booting depends

on the number of infotainment functions

and may take longer than normal in the

event of very high or very low temperatures.

●

Restrictions on the use of devices using

●

When selling or lending the vehicle, make

Bluetooth® technology may apply in some

countries. For further information, contact

the local authorities.

sure that all saved data, files and settings

have been deleted and, if necessary, exter-

nal audio sources and data media have been

removed.

●

If you disconnect the 12-volt battery, turn

on the ignition before restarting the infotain-

ment system.

●

When using the infotainment system and

Note

corresponding accessories, e.g., head-

phones, bear in mind country-specific regu-

lations and legal provisions.

●

If the setup is changed, this may change

You will find more information and tips for

using the infotainment system in the Help

menu.

the display on the screen and in some cases,

the infotainment system may behave in a

manner different to that described in this in-

struction manual.

●

Some functions of the infotainment system

require an active CUPRA CONNECT user ac-

count and an Internet connection for the ve-

hicle. The data transmission must not be

limited to perform the functions.

●

Ensure that any repairs or modifications

HOME screen

that need to be carried out on the infotain-

ment system are carried out by a specialised

workshop. To do so, CUPRA recommends

going to a specialised CUPRA dealer or any

SEAT dealership.

In the control and display unit you can set up

the views and representation on the home

screen or use the factory setting templates.

●

To use the infotainment system, simply

lightly press a button or touch the screen.

●

For the correct operation of the infotain-

If an icon is missing on the screen, it is not a

device defect, but corresponds to the spe-

cific equipment of the country or version.

ment system it is important that it is switched

on and that, if necessary, the time and date

of the vehicle are set correctly.

●

Using a mobile phone device inside the ve-

hicle may cause noise in the speakers.

»

167

Infotainment system

The following menus can be included as an

icon on the home screen:

Moving objects and adjusting volume

Managing the infotainment sys-

tem

Move objects on the screen to adapt set-

tings, for example, with scrollable buttons or

to move the areas of a menu.

Main menus on the home screen

Execute the functions and settings with the

infotainment controls.

Navigation page 193

›››



Depending on the equipment, customise

menus and views.

Radio page 186 , Multimedia

›››

Depending on the equipment, the infotain-

ment system has different controls:



page 190

›››

Increasing and reducing images or map

sizes

Telephone page 200

●

›››

Touch screen.



●

Touch zones outside the screen, for exam-

ple, Volume (+ -).

Full Link page 178

›››

Tip: use your thumb and index finger.



●

Press on the map with both fingers at the

same time and leave them on the screen.

Setup page 169

›››



Help Menu

●

To enlarge views, slowly separate one fin-

Vehicle page 89

›››

This menu displays information on the oper-

ation of the infotainment system and gives

practical tips.



ger from the other. To reduce views, slowly

bring one finger towards the other.

Data page 88

›››



●

Press  Help.

Air conditioning page 147

›››

Note



If you turn on the infotainment system

manually with the ignition off, it will auto-

matically turn off after about 30 minutes.

Sound

Connecting and disconnecting the info-

tainment system



Users



The infotainment system turns on when the

ignition is switched on, unless it has been

manually turned off beforehand.

Store



Customising the infotainment

system

Legal

The infotainment system starts-up with the

last set volume, provided that this does not

exceed the preset maximum start-up vol-

ume.



Help

Customise the menus and infotainment

views to quickly access your favourite or

most frequently used functions.



The infotainment system automatically turns

off when the driver's door is opened, provi-

ded the ignition has been switched off be-

forehand.

The main menu contains function buttons

for accessing all of the Infotainment apps.

168

Introduction

Configuring customised menus

●

You can add a maximum of two more cus-

Symbol and its meaning

tomised menus (in total, a maximum of four

customised menus).

In all views (except Main Menu, StandBy,

Parking, Speller and Full Link), you will find

shortcuts to customizable system functions

in the lower part of the screen. Use the set-

tings to delete or replace them, or change

their order.

The setting is not selected, disabled or

disconnected.

^/

●

For some function buttons, more func-

To open a drop-down list.

tions are available than those seen at first

sight in the additional window. To find all

the functions, in the additional window

slide the screen to the left or right.









To increase a setting value.

To go back step by step.

To go forward step by step.

●

Press and hold one of the icons (or press

●

For the drop-down menu, more functions

on the icon of an empty position) to display

an additional window.

are available than those seen at first sight in

the additional window. To find all the func-

tions, in the additional window slide the

screen to the left or right.



●

Select one of the icons from the apps bar.

Press  to delete an icon.

To change a setting value with the scrol-

lable button without adjusting.



●

The shortcut bar cannot be edited when

Click on an icon in the additional window

the vehicle is moving.

to replace the value.

Sound settings

●

Hold your finger on one of the icons and

drag it to the desired position.

Accessing the sound settings: press 

Sound

Settings (system and sound)

●

To close the edit mode, press  in the ad-

In the sound settings there may be the fol-

lowing functions, information and setting

options:

ditional window.

The selection of possible settings varies de-

pending on the country, the equipment in

question and the equipment of the vehicle.

Adapting customised menus

●

Press a function button in a customised

●

Equaliser.

Position.

Settings.

Modifying settings

menu and keep your finger on the screen

until an additional window is displayed.

The meaning of the following symbols are

valid for all system and sound settings.

●

Press the function button to which you

want to add a function.

All changes are automatically applied when

the menus are closed.

System settings

●

Click close to return to the custom menu.

Accessing the system settings: press  Set-

tings.

»

Note

Symbol and its meaning

●

At least two customised menus are always

The setting is selected and activated or

connected.

^/

available. These cannot be deleted.

169

Infotainment system

In the system settings there may be the fol-

lowing functions, information and setting

options:

If the sound from the connected external

audio source is too loud or distorted, lower

the output volume on the external audio

source. If this is not enough, change the in-

put volume to medium or low.

Trademarks, licenses and copy-

rights

Registered trademarks and licenses

●

Screen.

Certain terms in this manual bear the symbol

® or ™. These symbols indicate that it is a

trademark or a registered trademark. The

absence of this symbol, however, does not

necessarily mean that the term in question

can be used freely.

Time and date.

Language.

Clean the screen

Additional keypad languages.

Units.

Remove persistent dirt carefully and without

using aggressive cleaning products. To clean

the screen we recommend that:

Voice control.

Other product names are registered trade-

marks or trademarks of the respective rights

holders.

Wi-Fi.

Data connection.

Manage mobile devices.

Reset factory settings.

System information.

Copyright.

●

The infotainment system is switched off.

Use a clean, soft cloth dampened with wa-

●

Manufactured under license from Dolby

Laboratories. Dolby and the double-D sym-

bol are trademarks of Dolby Laboratories.

ter page 353 .

›››

●

In case of persistent dirt: soften the dirt by

moistening with a little water. Then carefully

remove with a clean, soft cloth.

●

Manufactured under license from Dolby

Laboratories. Dolby and the double-D sym-

bol are trademarks of Dolby Laboratories.

Configuration wizard.

CAUTION

Adjust the volume of external audio sour-

ces

●

Android Auto™ is a trademark of Google

Cleaning the screen with inappropriate

cleaning products or when dry, may dam-

age it.

Inc.

●

If you need to increase the playback volume

for the external audio source, first lower the

volume on the infotainment system.

Apple CarPlay™ is a trademark of Apple

Inc.

●

When cleaning, only press lightly.

●

Bluetooth® is a registered trademark of

Do not use aggressive cleaning products

Bluetooth® SIG, Inc.iPod®, iPad® and

iPhone® are trademarks of Apple Inc.

If the sound from the connected audio

source is very low, increase the output vol-

ume on the external audio source. If this is

not enough, change the input volume to

medium or high.

or that contain solvents. Such products

may damage the equipment and “darken”

the screen.

●

MirrorLink™ and MirrorLink Logo are certi-

fied trademarks of Car Connectivity Consor-

tium LLC.

170

Introduction

■

●

Windows® is a registered trademark of Mi-

crosoft Corporation, Redmond, USA.

The corresponding indications are shown on

the control and display unit screen and partly

on the instrument panel.

7 speakers: 5 frequency bands or pre-

defined settings.

■

Sound distribution, depending on the

system:

●

MPEG-4 HE-AAC audio coding technology

and patents are licensed by Fraunhofer IIS.

■

Capacitive colour screen:

■

7 speakers: Balance + Fader (left /

right / front / rear).

●

■

This product is protected by certain Micro-

Using the equipment with:

soft Corporation industrial and intellectual

property rights. The use or commercializa-

tion of technology of this type outside the

configuration of this product, without a li-

cence from Microsoft or an authorised Mi-

crosoft branch is prohibited.

■

Touch zones Touch operation.

Sound optimisation by zones (valid for

the 7 speaker system):

■

Buttons on the multifunction steering

wheel.

■

Manual (Driver and All)

■

Proximity sensors and gesture control.

■

Automatic depending on the seats oc-

cupied.

Vehicle and comfort functions

■

Driver assistance system settings.

Copyright

Optional sound system

■

Heating and air conditioning settings.

As a general rule, audio and video files stored

on data media and audio sources are subject

to intellectual property protection in accord-

ance with the national and international pro-

visions applicable in each case. Please bear

in mind all legal provisions!

The infotainment system can be extended

with an optional sound system as follows:

■

Lights and visibility function settings.

■

Vehicle comfort settings.

■

10 speakers in different locations and with

Parking and manoeuvring settings.

different power levels (watts).

■

External amplifier (340 W Ethernet), which

processes the audio signals sent by the

central computer.

Sound system

■

Excitation of speaker channels through

class AB final stages.

Technical data

Basic equipment:

The infotainment system that is supplied

from the factory is equipped as follows:

■

Central computer with control and display

unit

Audio signal processing in digital internal

signal processor (DSP).

■

Speakers in different locations and with

different power levels (watts).

■

Independent subwoofer in the luggage

compartment.

The factory-mounted central computer in

the vehicle includes country-specific com-

ponents and software for connectivity and

for the execution of vehicle, comfort and in-

fotainment functions.

■

Internal amplifier depending on the sys-

tem:

■

Setting options:

■

User equaliser: 5 bands.

■

7 speakers: 5 x 20 W

■

Equaliser settings predefined by BEATS®

■

Setting options:

»

(Signature, Active, Immersive and Voice).

■

Equaliser, depending on the system:

171

Infotainment system

■

Sound distribution: Balance + Fader

(left / right / front / rear).

Bluetooth® profiles

There can be a maximum of two mobile de-

vices connected to the Bluetooth® hands-

free and a third device connected to the

Bluetooth® as a music player.

Sound optimisation by zones:

■

Manual (Driver, Front and All)

■

Automatic depending on the seats oc-

cupied.

When a mobile phone is connected to the

telephone management system, a data ex-

change takes place via one of the Blue-

tooth® profiles.

■

Subwoofer volume.

Surround settings.

●

Hands-free telephone profile (HFP): the

Connectivity

HFP can be used to manage calls through

the infotainment system.

Wi-Fi

●

Audio profile (A2DP): This profile allows

■

Wi-Fi conforming to IEEE 802.11 b/g/n

audio to be transmitted with stereo quality. It

may require connecting other profiles for

managing and controlling playback.

■

2.4 GHz and 5 GHz transfer (depending on

the country)

■

Two Wi-Fi modes at the same time:

●

Phone book access profile (PBAP): Al-

■

Tethering.

lows phone book contents to be downloa-

ded from the mobile telephone.

■

Access point.

■

Simultaneous connection of up to 8 Wi-Fi

●

Message profile (MAP): It allows short

devices.

messages (SMS) and emails to be downloa-

ded and synchronised.

■

Internet connection via Wi-Fi:

■

Tethering through the customer's

phone.

■

Access point for customers in the vehi-

cle.

■

Apple CarPlay and Android Auto over Wi-

Fi.

■

Pairing process simplified by WPS or QR

code.

172

Infotainment system -> General instructions for use for Your Cupra Formentor SUV First Generation (2020-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals