NOTICE
●
In certain circumstances, the ultrasonic
sensors do not detect objects such as trailer
hitches, bars, fences, posts or thin trees, or
an open (or opening) rear lid, which could
damage the vehicle.
●
Retrotting of certain accessories to the
vehicle, such as a bicycle rack, may interfere
with the operation of the automatic parking
system and cause damage.
●
The automatic parking system uses as a
reference parked vehicles, kerbs and other
objects. Make sure that the tyres and wheels
are not damaged while parking. If necessary,
interrupt the parking manoeuvre on time to
avoid damaging the vehicle.
●
The ultrasound sensors on the bumper may
be damaged or shifted in the event of a colli-
sion, for example, when entering or exiting a
parking space.
●
If you use high-pressure or steam equip-
ment to clean the ultrasound sensors, do not
apply it directly unless very briey and always
from a distance of more than 10 cm.
●
A registration plate or plate holder on the
front that is larger than the space for the reg-
istration plate, or a registration plate that is
curved or warped can cause:
–
False detections.
–
The sensors to lose visibility.
–
Cancellation of the parking manoeuvre
or defective parking.
●
If one of the ultrasonic sensors is damaged,
the area corresponding to that group of sen-
sors (front or rear) is deactivated and can-
not be activated until the fault is corrected.
However, you can still use the sensors of the
other bumper as per usual. If there is a fault
in the system, consult a specialist workshop.
CUPRA recommends going to a specialised
CUPRA dealer or any SEAT dealership for this
purpose.
Note
●
In order to guarantee good system oper-
ation, keep the ultrasound sensors of the
bumper clean, free of snow or ice, and do not
cover them with stickers or other objects.
●
Certain sources of noise, such as rough as-
phalt or paving stones and the noise of other
vehicles can induce the automatic parking
system or ParkPilot to give erroneous warn-
ings. The presence of metal objects can also
aect the manoeuvre.
●
To become familiar with the system and
its functions, CUPRA recommends that you
practice operating the automatic parking
system in an area where there is not too
much traic or in a car park.
Description of the automatic park-
ing system
The components of the automatic parking
system are the ultrasonic sensors located in
the front and rear bumpers, the
button to
switch the system on and o and the messages
on the infotainment system display.
Prerequisites for parking
●
The traction control (TCS) must be switched
on ›››page191.
●
Speed when passing next to the parking
space: do not exceed approx. 50km/h
(31mph).
●
Keep a distance between 0.5and2.0metres
when driving past the parking space.
●
Space length (parallel parking): vehicle
length +1meter.
●
Space width (parking bay): vehicle width
+1.1meters.
Requirements for leaving the parking space
(only for parallel parking)
●
The traction control (TCS) must be switched
on ›››page191.
●
Space length: length of the vehicle
+0.5metres.