59
03
Ease of use and comfort
Thermal pre-conditioning
(Hybrid)
This function allows you to programme the
vehicle to adjust the passenger compartment
temperature to a pre-defined, non-modifiable
temperature (approx. 21°C) before you enter the
vehicle, on the days and times of your choice.
The programmable heating is supplied by
the vehicle fuel tank. Before use, make
sure that you have sufficient fuel. If the fuel
tank is on reserve, you are strongly
recommended not to program the heating.
The additional heating must always be
switched off while refuelling to avoid any risk
of fire or explosion.
►ꢀ Use a coin to unscrew the cap and replace the
battery.
Programming
(With DS CONNECT NAV)
In the Climate > OPTIONS menu:
Select Temperature conditioning.
Do not throw remote control batteries
away, as they contain metals that are
harmful to the environment. Take them to an
approved disposal point.
To avoid the risks of poisoning or
asphyxia, the programmable heating
must not be used, even for short periods, in a
closed environment such as a garage or
workshop which is not equipped with an
exhaust gas extraction system.
Do not park the vehicle on a flammable surface
(dry grass, dead leaves, paper, etc.) - Risk of
fire!
►ꢀ Press + to programme.
►ꢀ Select the time of entry into the vehicle and
the desired days. Press OK.
►ꢀ Press ON to activate this programming.
Pre-conditioning begins approximately 45 minutes
before the programmed time, and is maintained
for 10 minutes afterwards.
The maximum heating period is about
45 minutes depending on the climatic
conditions.
The ventilation is activated provided that
the battery is sufficiently charged.
The heating is activated provided that:
– the battery charge and the fuel level are
sufficient,
Glazed surfaces such as the rear screen or
windscreen can become very hot in
places.
Never put objects on these surfaces; never
touch these surfaces - Risk of burns!
– the engine has been started since the
previous heating cycle,
– 60 minutes have elapsed between two
heating requests.
This indicator lamp remains lit throughout the
pre-conditioning phase.
English 
