128
Driving
06
– At reduced speed in an urban environment,
when a stationary vehicle, pedestrian or cyclist is
detected.
Have it checked by a dealer or a qualified
workshop.
In certain driving conditions (poor road
surface or strong winds), the system may
give alerts independent of the driver's level of
vigilance.
If these warning lamps come on
– The vehicle's speed is between 6 mph and
53 mph (10 km/h and 85 km/h) (versions with
camera only) or 87 mph (140 km/h) (versions
with camera and radar) when a moving vehicle is
detected.
after the engine has been switched
off and then restarted, contact a dealer or a
qualified workshop to have the system checked.
These warning lamps light up on
The following situations may interfere
with the operation of the system or
prevent it from working:
the instrument panel to indicate
This warning lamp flashes (for
that the driver's and/or front passenger's seat
belt is not fastened (depending on version). The
automatic braking system is deactivated until the
seat belts are fastened.
– lane markings absent, worn, hidden (snow,
mud) or multiple (roadworks);
approximately 10 seconds) as soon as the
function applies the vehicle’s brakes.
In the event of automatic emergency braking
bringing the vehicle to a complete stop, keep the
brake pedal depressed to prevent the vehicle from
moving off again.
– close to the vehicle ahead (lane markings
not detected);
– roads that are narrow, winding, etc.
Distraction detection
Activation/Deactivation
For more information, refer to the General
recommendations on the use of driving
and manoeuvring aids.
The driver can maintain control of the
vehicle at any time by firmly turning the
steering wheel and/or firmly depressing the
accelerator pedal.
This function is set via the touch screen
Driving/Vehicle menu.
The state of the system is memorised when the
ignition is switched off.
The function comprises the "Driver Attention
Warning" and "Driver Attention Warning by
Camera" systems, combined, depending on
version, with the "DS DRIVER ATTENTION
MONITORING" system.
The brake pedal may vibrate slightly while
the function is operating.
Driver Attention Warning
The system triggers an alert when it
detects that the driver has not taken a
break after two hours of driving at a speed above
43 mph (70 km/h).
If the vehicle comes to a complete stop,
automatic braking is maintained for 1 to 2
seconds.
These systems are in no way designed to
keep the driver awake or to prevent the
driver from falling asleep at the wheel.
It is the driver’s responsibility to stop if feeling
tired.
This alert is issued via the display of a message
encouraging the driver to take a break,
accompanied by an audible signal.
Malfunction
In the event of a malfunction, this warning
lamp lights up on the instrument panel,
accompanied by the display of a message and an
audible signal.
If the driver does not follow this advice, the alert
is repeated hourly until the vehicle is stopped.
The system resets itself if one of the following
conditions is met:
Take a break if you are feeling tired or at least
every 2 hours.
English 
