GETTING TO KNOW YOUR VEHICLE 43
High Beams
Follow Me Home/Headlight Delay
With the low beams activated, push the multifunction lever
forward (toward the front of the vehicle) to turn on the
high beams. The lever will remain forward in a fixed
position and the telltale will illuminate in the instrument
cluster display. Pull the multifunction lever rearward (to-
ward the rear of the vehicle) to turn off the high beams.
When this feature is selected, the driver can choose to have
the headlights remain on for a preset period of time after
the engine is turned OFF.
3
Activation
Remove the key or turn the ignition to the STOP (OFF/
LOCK) position, and pull the multifunction lever toward
the steering wheel within two minutes. Each time the lever
is pulled, the activation of the lights will be extended by 30
seconds. The activation of the lights can be extended to a
maximum of 210 seconds.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and remain
on, until the lever is released.
Deactivation
Parking Lights
Pull the multifunction lever toward the steering wheel and
hold it for more than two seconds.
To turn on the parking lights, remove the key or turn the
ignition to STOP (OFF/LOCK) position and turn on the
headlights.
Front Fog Lights — If Equipped
The fog light switch is located on the center stack of the
instrument panel, just below the radio. Push the switch
once to turn the front fog lights on. Push the switch a
second time to turn the front fog lights off.
NOTE: If the parking lights are left on and the key is in the
stop position with the door open, an audible chime will
sound and a message will show in the instrument cluster
display. The chime will stop as soon as the door is closed or
the lights are switched off.