2006-2014 Nissan Qashqai SUV Instruments and controls -> Power windows User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> Power windows for Your Nissan Qashqai SUV First Generation (2006-2014)

WINDOWS  
POWER WINDOWS  
The power window switches are located on the door  
panel and will only operate when the ignition switch  
is in the ON position.  
WARNING  
Make sure to remove the key from the ignition  
•
switch and take it with you when leaving the  
vehicle. If children are left unattended inside  
the vehicle they could unknowingly activate  
switches.  
NPA991  
NPA992  
Removal:  
Storage:  
Make sure that all passengers have their  
•
1) Pull the tonneau cover at the grip j1 slightly up  
1) Remove the luggage floor covers j1 , j2 and  
j3 .  
hands, etc. inside the vehicle while it is in  
motion and before closing the windows. Use  
the power window lock switch to prevent un-  
expected use of the power windows.  
and backward, then slide it forward.  
2) Push the sliding button j2 at the right hand side  
2) Fit the tonneau cover under the luggage com-  
partment floor in it’s storage space. Use the  
straps j4 at the right and left side.  
to disengage it from the groove.  
It is recommended to instruct all occupants in  
•
3) Then remove the tonneau cover j3 completely.  
the safe operation of power windows with par-  
ticular emphasis given to the safety and su-  
pervision of children.  
3) Replace the covers j1 , j2 and j3 .  
To fit the tonneau cover, first fit the left side, then at  
the right hand side, push it into the groove j2 until  
the stem engages.  
NIC1309Z  
Left hand drive models  
2-34 Instruments and controls  
Downloaded from manuals search engine  
To stop the window opening or closing, just push or  
pull the switch in the opposite direction.  
To activate the power window lock function, push  
the switch.  
Auto-reverse function:  
To cancel the power window lock function, push the  
switch again.  
When the control unit detects an object obstructing  
the driver’s side window, as it closes, the window  
will open automatically.  
System reinitialisation:  
The driver’s side main power window system will  
require reinitialisation whenever:  
The auto-reverse function remains active only when  
the driver’s side window is being closed automati-  
cally.  
The power window system does not function  
properly for example the auto-reverse function is  
not working.  
•
NIC1377Z  
Right hand drive models  
WARNING  
The battery cable is reconnected.  
Driver’s side main switch  
•
•
There are some areas immediately before the  
closed position where squeezing cannot be  
detected. Be careful not to pinch your fingers.  
•
The fuse is replaced.  
Driver’s side automatic window switch  
j1  
j2  
j3  
Perform the following procedure to initialise the  
power window system.  
Power window lock switch  
The auto-reverse function does not work  
when the window is closed manually (holding  
the switch in the close position).  
•
Passenger power window switches  
1. Turn the ignition switch to the ON position  
2. Close the door.  
The driver’s side control panel is equipped with  
switches to operate the passenger power windows  
and a power window lock switch.  
CAUTION  
3. Push down and hold the driver’s side window  
switch until the window glass is completely low-  
ered then release the switch.  
Depending on the environment or driving condi-  
tions, the auto-reverse function may be activated  
if an impact or load similar to something being  
caught in the window occurs.  
Automatic operation:  
WARNING  
4. In one continuous operation, pull up and hold  
the driver’s side window switch until the window  
glass is completely closed and continue holding  
the switch for a further 5 seconds.  
Make sure there is no obstruction when closing  
the driver’s side window using the driver’s side  
automatic window switch.  
Power window lock switch:  
Dependant on the vehicle specifications, when the  
power window lock function is activated, either:  
5. The system is now reinitialised.  
To fully open the driver’s side window, completely  
push down or pull up the driver’s side automatic  
window switch and release it; it does not need to be  
held. The window will automatically open or close all  
the way.  
the rear passenger window switches are dis-  
abled; or  
•
If the reinitialisation procedure cannot be performed  
successfully, take your vehicle to a NISSAN dealer  
or qualified workshop.  
the front and rear passenger window switches  
are disabled.  
•
Instruments and controls 2-35  
Downloaded from manuals search engine  

Related Topics

Popular Owner Manuals