[ Edit: 2014/ 11/ 7 Model: T32-A ]
Locking passenger’s windows:
GUID-22018305-9BAB-4201-B6FC-C08EB94AEAE0
When the lo ck button
*
A
is pus hed in, the
passenger’s windows cannot be operated.
To cancel the passenger’s windows lock, push the lock
button
*
A
again.
Passenger’s window switch (if equipped)
T32A130827-1E760836-570A-4B73-80E9-9AEA15B33E1E
SIC4523
The passenger’s switch can control its corresponding
window.
When the passenger’s windows lock button on the
driver’s switch is pushed in, the passenger’s switch
cannot be operated.
Automatic function
T32A130827-D7ACC763-0E96-4CE0-BE1C-FF34F4B3CC4F
SIC4524
The automatic function is available for the switch that
has an
mark on its surface.
The automatic function enables a window to fully open
or close without holding the switch down or up.
To fully open the window, push the power window
switch down to the second detent and release the
switch. To fully close the window, pull the power
window switch up to the second detent and release
the switch. The switch does not have to be held during
window operation.
To stop the window open/close operation during the
automatic function, push down or pull up the switch in
opposite directions.
Auto-reverse function:
GUID-22018305-9BAB-4201-B6FC-C08EB94AEAE0
WARNING:
There is a small distance just before the closed
position which cannot be detected. Make sure
that all passengers have their hands, etc. inside
the vehicle before closing the windows.
The auto-reverse function enables a window to
automatically reverse when something is caught in
the window as it is closing by the automatic function.
When the control unit detects an obstacle, the window
will be lowered immediately.
Depending on the environment or driving conditions,
the auto-reverse function may activate if an impact or
load similar to something being caught in the window
occurs.
If the window does not close automatically
GUID-1AF95C11-1513-41B2-A58D-44F35B4E3E28
If the power window automatic function (closing only)
does not operate properly, perform the following
procedure to initialize the power window system.
1. Place the ignition switch in the “ON” position.
2. Close the door.
3. Open the window completely by operating the
power window switch.
4. Pull the power window switch and hold it to close
the window, and then hold the switch more than 3
seconds after the window is closed completely.
5. Release the power window switch. Operate the
window by the automatic function to confirm the
initialization is complete.
If the power window automatic function does not
operate properly after performing the procedure above,
have your vehicle checked by a NISSAN dealer.
Instruments and controls 2-51
Condition: 'Except for China'/
English 
