AdBlue® TANK (if equipped for
diesel engine model)
DRIVE BELT
3. Place the ignition switch in the “OFF”
position.
REFILLING THE AdBlue® TANK
When the “AdBlue low” or “Refill AdBlue” warn-
ing appears in the vehicle information display,
refill the AdBlue® tank before the tank is empty
(see “AdBlue® Selective Catalytic Reduction
(SCR) system (if equipped for diesel engine
model)” (P.5-5)). Refill the AdBlue® tank accord-
ing to the procedures shown in this section.
4. Open the AdBlue® filler lid.
5. Remove the AdBlue® tank cap by turning it
counterclockwise.
6. Refill the AdBlue® tank.
7. Securely install the AdBlue® tank cap.
8. Close the AdBlue® filler lid.
CAUTION:
9. Place the ignition switch in the “ON” posi-
tion and wait for approximately 1 minute
until the “AdBlue low” or “Refill AdBlue”
warning turns off.
JVM0398X
.
.
Use only AdBlue®. Using other fluids will
damage the AdBlue® Selective Catalytic
Reduction (SCR) system.
QR25DE engine
Crankshaft pulley
1.
2.
3.
4.
5.
Drive belt auto-tensioner
Water pump
NOTE:
Be careful not to spill AdBlue®. If the
AdBlue® is spilled on the vehicle body,
wipe it away with a wet cloth immedi-
ately to avoid paint damage.
.
In the case that the “ENG can’t start Refill
AdBlue” warning is displayed, place the
ignition switch in the “ON” position and
check that the warning has turned off.
Then, start the engine.
Alternator
Air conditioner compressor
.
.
AdBlue® residues crystallize after a peri-
od of time and contaminate the paint
surfaces. If the spilled AdBlue® has crys-
tallized, use a sponge and cold water to
clean it.
.
AdBlue® can freeze at very low tempera-
tures (−11°C/12°F). In extremely cold con-
ditions the system may not be able to
detect that the system has been refilled
and will continue to display the “AdBlue
low” or “Refill AdBlue” warning. The warn-
ing message will disappear when the
contents of the AdBlue® tank have
thawed.
Be careful not to inhale any ammonia
vapours that may be released. Fill the
AdBlue® tank in well-ventilated areas.
The AdBlue® tank is located underneath the
vehicle. (See “AdBlue® filler lid and cap (if
equipped for diesel engine model)” (P.3-33) for
the AdBlue® filler lid location.)
SDI1881
MR20DD engine
1. Apply the parking brake.
1.
Alternator
2. Continuously Variable Transmission (CVT)
model: Move the shift lever to the “P” (Park)
position.
2.
3.
4.
5.
Drive belt auto-tensioner
Crankshaft pulley
Air conditioner compressor
Water pump
Manual Transmission (MT) model: Move the
shift lever to the “N” (Neutral) position.
8-18 Maintenance and do-it-yourself
English 
