Get Maintenance and do-it-yourself -> Fuses Guide for Nissan X Trail SUV Fourth Generation (2022-2026)

VARIABLE VOLTAGE CONTROL

SYSTEM (if equipped)

FUSES

The variable voltage control system measures

the amount of electrical discharge from the

battery and controls voltage generated by the

alternator.

ENGINE COMPARTMENT

CAUTION:

.

Do not ground accessories directly to the

battery terminal. Doing so will bypass the

variable voltage control system and the

vehicle battery may not charge comple-

tely.

SDI1753

Use electrical accessories with the engine

running to avoid discharging the vehicle

battery.

Type A

JVM0386X

QR25DE engine model (Example)

CAUTION:

Never use fuse of

a

higher or lower

amperage rating than that specified on the

fuse box cover. This could damage the

electrical system or cause a fire.

If any electrical equipment does not operate,

check for an open fuse.

SDI1754

1. Be sure the ignition switch is in the “OFF”

position.

Type B

7. Remove the fuse using the fuse puller

located in the passenger compartment.

2. Be sure the headlight switch is in the “OFF”

position.

8. If the fuse is open , replace it with a new

fuse

3. Open the engine hood.

.

4. Remove the air cleaner duct. (See “Engine

compartment check locations” (P.8-6).)

If the new fuse also opens, after installing, have

the electrical system checked, and if necessary

repaired, by a NISSAN dealer.

5. Remove the fuse/fusible link box cover by

using a suitable tool and pushing the tab.

6. Locate the fuse that needs to be replaced.

8-30 Maintenance and do-it-yourself

Outer side of the instrument panel

JVM0444X

QR25DE engine model (Example)

The holder also contains the fuses. For

checking and/or replacing, see a NISSAN dealer.

JVM0783X

For all LHD model

Fusible links

If any electrical equipment does not operate

and the fuses are in good condition, check the

fusible links. If any of these fusible links are

melted, replace only with genuine NISSAN

parts.

PASSENGER COMPARTMENT

CAUTION:

JVM0784X

Never use

a

fuse of

a

higher or lower

For Stop/Start System or Idling Stop System (if equipped)

1. Be sure the ignition switch is in the “OFF”

position.

amperage rating than that specified on the

fuse box cover. This could damage the

electrical system or cause a fire.

2. Be sure the headlight switch is in the “OFF”

position.

If any electrical equipment does not operate,

check for an open fuse.

3. Remove the fuse box cover.

4. Locate the fuse that needs to be replaced.

5. Remove the fuse using the fuse puller

.

SDI1754

Maintenance and do-it-yourself 8-31

6. If the fuse is open , replace it with a new

fuse

Glove box

.

If the new fuse also opens, after installing, have

the electrical system checked, and if necessary

repaired, by a NISSAN dealer.

JVM0786X

For all RHD model

1. Be sure the ignition switch is in the “OFF”

position.

2. Be sure the headlight switch is in the “OFF”

position.

3. Open the glove box and unlock the damper

.

4. Hold the glove box lid so that the distance

between the upper end of the lid and the

dashboard is about 5 cm (2 in), and then

pull off the hinges

side of the lid.

located on the under-

SDI1754

5. Unlock the left and right stoppers

remove the glove box lid.

and

8. If the fuse is open

fuse

, replace it with a new

.

6. Locate the fuse that needs to be replaced.

7. Remove the fuse using the fuse puller.

If the new fuse also opens, after installing, have

the electrical system checked, and if necessary

repaired, by a NISSAN dealer.

8-32 Maintenance and do-it-yourself

LIGHTS

2. Be sure the headlight switch is in the “OFF”

position.

Extended storage fuse switch

HEADLIGHTS

LED headlight bulb

If replacement is required, contact a NISSAN

dealer.

3. Remove the fuse box cover.

4. Pinch the locking tabs found on each

side of the extended storage fuse switch.

5. Pull the extended storage fuse switch

straight out from the fuse box

Halogen headlight bulb

.

The halogen headlight is a semi-sealed beam

type which uses replaceable headlight (halo-

gen) bulbs. They can be replaced from inside

the engine compartment without removing the

headlight assembly.

How to remove the extended storage fuse

switch:

1. To remove the extended storage fuse

switch, be sure the ignition switch is in the

“OFF” or “LOCK” position.

JVM0415X

CAUTION:

Example

2. Be sure the headlight switch is in the “OFF”

position.

To reduce battery drain, the extended storage

fuse switch comes from the factory switched

off. Prior to delivery of your vehicle, the switch is

pushed in (switched on) and should always

remain on.

High-pressure halogen gas is sealed inside

the bulb. The bulb may break if the glass

envelope is scratched or the bulb is dropped.

3. Remove the fuse box cover.

4. Pinch the locking tabs found on each

side of the extended storage fuse switch.

5. Pull the extended storage fuse switch

straight out from the fuse box

If the extended storage fuse switch is not

pushed in (switched on), the “Shipping Mode

On Push Storage Fuse” warning may appear in

the vehicle information display. See “Vehicle

information display warnings and indicators”

(P.2-30).

.

If any electrical equipment does not operate,

remove the extended storage fuse switch and

push it in again.

NOTE:

If the extended storage fuse switch malfunc-

tions, see a NISSAN dealer.

How to remove the extended storage fuse

switch:

1. To remove the extended storage fuse

switch, be sure the ignition switch is in the

“OFF” or “LOCK” position.

Maintenance and do-it-yourself 8-33

Maintenance and do-it-yourself -> Fuses for Your Nissan X Trail SUV Fourth Generation (2022-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals