2001-2014 Peugeot 307 4 Door Practical Information -> Changing a Wheel (Saloon) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Practical Information -> Changing a Wheel (Saloon) for Your Peugeot 307 4 Door 2001-2014

First activation/  
memorising a reference speed  
CRUISE CONTROL*  
Instrument panel display  
As soon as you reach the chosen  
speed, press button 2 3. This mem-  
orises the speed and the display indi-  
cates (e.g. at 70 mph (110 km/h)):  
This cruise control has a display on  
the instrument panel to indicate the  
memorised reference speed.  
It enables the vehicle to maintain a  
steady speed programmed by the  
driver.  
In order for it to be memorised or ac-  
tivated, the vehicle speed must be  
greater than 25 mph (40 km/h) with  
at least fourth gear engaged for vehi-  
cles fitted with a manual gearbox.  
On vehicles fitted with an automatic  
gearbox, the lever must be in posi-  
tion D or at least second gear must  
be engaged in sequential driving  
mode.  
When the cruise control function is ac-  
tivated, pressing this button enables  
you to display the distance recorder.  
After a few seconds or when this  
button is pressed again, the display  
returns to the cruise control function.  
Note: It is possible to accelerate  
and drive momentarily at a speed  
greater than the memorised speed.  
The value memorised flashes. When  
the accelerator pedal is released, the  
vehicle will return to the memorised  
speed.  
Cancelling the cruise control  
If you wish to cancel the cruise control:  
Press button 4 or the brake or  
clutch pedal.  
The display indicates (e.g. at 70 mph  
(110 km/h)):  
Selecting the function  
Place switch 1 in the ON position.  
The cruise control is not yet active  
and no speed has been memo-  
rised. The display indicates:  
* According to country.  
102  
Reactivating the cruise control  
To memorise a speed lower than the  
previous one:  
press button 2;  
A brief press decreases by 1 mph  
(1 km/h).  
When changing the memo-  
rised reference speed by  
means of a maintained press,  
pay attention as the speed  
can increase or decrease rapidly.  
Do not use the cruise control on  
slippery roads or in heavy traffic.  
After cancellation of the cruise con-  
trol, press button 4. Your vehicle will  
return to the last memorised speed.  
The display indicates (e.g. at 70 mph  
(110 km/h)):  
An extended press decreases by  
5 mph (5 km/h).  
A maintained press decreases in  
steps of 5 mph (5 km/h).  
In the event of a steep slope, the  
cruise control cannot prevent the  
vehicle from exceeding the pro-  
grammed speed.  
In any event, the cruise control can-  
not replace the need to observe the  
speed limits, nor can it replace the  
need for vigilance and responsibility  
on the part of the driver.  
To prevent the mat from becoming  
caught under the pedals:  
- ensure that the mat is positioned  
correctly.  
- never fit one mat on top of another.  
Cancelling the memorised  
reference speed  
When the vehicle is stationary, af-  
ter the ignition has been switched  
off, the system no longer stores  
any speed.  
Changing the memorised  
reference speed  
To memorise a speed higher than the  
previous one, there are two options:  
Without using the accelerator:  
press button 3;  
A brief press increases by 1 mph  
(1 km/h).  
Switching the function off  
Place dial 1 in the OFF position to  
switch the system off.  
An extended press increases by  
5 mph (5 km/h).  
A maintained press increases in  
steps of 5 mph (5 km/h).  
Operating fault  
In the event of a cruise control mal-  
function, the memorised speed is  
erased, the dashes flash for a few  
seconds:  
Using the accelerator:  
exceed the memorised speed un-  
til the required speed is reached,  
press button 2  
3
Contact a PEUGEOT dealer to have  
the system checked.  
103  
VISUAL AND AUDIBLE REAR  
PARKING ASSISTANCE  
Switching the system off  
This system consists of four proximity  
sensors, located in the rear bumper.  
This detects any obstacle (person,  
vehicle, tree, gate, etc.) behind the  
vehicle. Nevertheless, it cannot de-  
tect obstacles located just below the  
bumper.  
An object, such as a stake, a road-  
works cone or any other similar  
object may be detected at the begin-  
ning of the manoeuvre, but may no  
longer be detected when the vehicle  
comes close to it.  
The proximity information is given by:  
- an audible signal, which becomes  
more rapid as the vehicle ap-  
proaches the obstacle,  
- a graphic on the multifunction dis-  
play, with blocks which become  
progressively closer to the vehicle.  
Change to neutral, the system is  
again inactive.  
Note: this function will be disarmed  
automatically when the vehicle is  
towing a trailer or when a bicycle car-  
rier is fitted (vehicle fitted with towing  
attachment or bicycle carrier  
Activation/Deactivation  
mended by PEUGEOT).  
The system can be activat-  
ed or deactivated from the  
multifunction display con-  
figuration menu.  
In bad or wintry weather, ensure that  
the sensors are not covered with  
mud, frost or snow. When reverse  
gear is engaged, an audible signal  
(long bleep) indicates that the sen-  
sors may be dirty.  
Depending on the multifunction dis-  
play, the audible signal is transmitted  
by a buzzer or by the rear speakers  
which transmit:  
The activation and deacti-  
vation of the system are memorised  
when the engine is switched off.  
- on the right if an obstacle is detect-  
ed on the right,  
- on the left if an obstacle is detected  
on the left,  
If there is an operating fault,  
when reverse gear is en-  
gaged, the service warning  
light comes on, accompanied  
by an audible signal (short bleep)  
and a message on the multifunction  
display.  
- on the right and on the left if an ob-  
stacle is detected in the centre.  
When the distance between the rear  
of the vehicle and the obstacle is  
less than approximately thirty centi-  
metres, the audible signal becomes  
continuous and the "Danger" symbol  
appears depending on the multifunc-  
tion display.  
Activation  
The system is activated as soon as  
reverse gear is engaged.  
This is accompanied by an audible  
signal and displaying of the vehi-  
cle, depending on the multifunction  
display.  
Contact a PEUGEOT dealer.  
104  

Related Topics

Popular Owner Manuals