Fitting a wheel
Position the wheel using the cen-
Wheels fitted with the Tyre
Under-Inflation Detection system
For further information refer to "Tyre
under-inflation detection" in the safe-
ty section.
After changing the wheel:
- have the correct positioning of the
punctured wheel, the tightening
of the bolts and the tyre pressure
checked by a PEUGEOT dealer as
soon as possible,
- have the punctured tyre repaired
and refit it to the vehicle as soon as
possible,
tralising tool 5 to assist you.
Tighten the bolts by hand and re-
move the centralising tool 5
Partly tighten the bolts using the
wheelbrace 1
Fold the jack 4 and remove it.
have the correct positioning of the
spare wheel checked by a PEUGEOT
dealer.
For your safety, always
change the wheel:
Fully tighten the bolts using the
wheelbrace 1
Replace the wheel trim, starting
by placing the wheel trim notch
opposite the valve, and press it on
using the palm of the hand.
Put the corresponding tools in the
holder and secure its cover.
Place the holder on the ground
and align the spare wheel on it.
Pass the notched hook into the
holder cover.
Refit the wheel under the vehicle
tightening the winch control nut
using the wheelbrace 1
Fully tighten and check that
the wheel is horizontally flush
against the rear floor
Close the flap using the lug to lock
the winch.
- on level, stable, non-slippery
ground,
- with the handbrake on and the igni-
tion switched off,
- with first or reverse gear engaged
(position P for the automatic gear-
box),
Recommendations when using
the temporary spare wheel*
Your vehicle may be equipped with a
spare wheel which has a different rim
to the standard wheel.
After use, it must be replaced as
quickly as possible.
Observe the following instructions to
avoid altering the behaviour of the
vehicle:
- do not exceed 50 mph (80 km/h)
- do not fit a wheel trim,
- drive with care,
- check the tyre pressure indicated
on the label.
- with the vehicle chocked.
Never go underneath a vehicle that
is supported only by a jack (use a
ramp).
Never refit the holder under the
vehicle without the spare wheel.
Do not use a screwdriver in place
of the wheelbrace to unwind or
wind the winch.
Store the rest of the tools in the
right-hand trim of the boot.
* According to model and country.
120
English 
