In the event of a breakdown -> Towing the vehicle for Your Peugeot 5008 SUV Second Generation (2017-2023)

In the event of a breakdown  
► Connect the (+) terminal of the front battery  
by connecting the red quick-release clamp:  
• Raise lever A fully.  
• Refit the open clamp B on the (+) terminal.  
• Push clamp B fully down.  
Towing the vehicle  
Procedure for having your vehicle towed or  
for towing another vehicle using a removable  
mechanical device.  
8
• Lower lever A to lock clamp B.  
► Connect the (-) terminal to the rear battery  
using the black quick-release terminal connector.  
General recommendations  
Observe the legislation in force in the  
country where you are driving.  
Ensure that the weight of the towing vehicle is  
higher than that of the towed vehicle.  
The driver must remain at the wheel of the  
towed vehicle and must have a valid driving  
licence.  
When towing a vehicle with all four wheels on  
the ground, always use an approved towing  
arm; rope and straps are prohibited.  
The towing vehicle must move off gently.  
When the vehicle is towed with its engine  
off, there is no longer braking and steering  
assistance.  
After reconnection  
After reconnecting the battery, turn on the  
ignition and wait 1 minute before starting the  
engine, to enable the electronic systems to  
initialise.  
► Disconnect the (+) terminal of the front  
battery by disconnecting the red quick-release  
clamp:  
• Raise lever A fully to release clamp B.  
• Remove clamp B by lifting it off.  
For right-hand drive versions, when the  
total distance recorder has reached  
62 miles (100 km), you must wait  
approximately 15 minutes before starting the  
engine.  
Reconnection  
Never reverse the order of the  
reconnection steps - risk of irreversible  
damage!  
If minor problems nevertheless persist following  
this operation, contact a PEUGEOT dealer or a  
qualified workshop.  
A professional towing service must be  
called if:  
Referring to the relevant section, reset certain  
equipment:  
– Remote control key or electronic key  
(depending on version).  
– Broken down on a motorway or main road.  
– Not possible to put the gearbox into neutral,  
unlock the steering, or release the parking  
brake.  
– Sunroof and electric sun blind.  
– Electric windows.  
– Date and time.  
– Not possible to tow a vehicle with an  
automatic gearbox, with the engine running.  
Towing with only two wheels on the ground.  
– Four-wheel drive vehicle.  
– Preset radio stations.  
– No approved towbar available.  
215  
In the event of a breakdown  
Hybrid vehicles  
Before any intervention, with the ignition on, depress the brake pedal and select mode N, then switch off the hybrid system (READY indicator lamp  
off).  
Always call on professionals for recovery of the vehicle on a flatbed lorry or trailer.  
Use the towing eye only to free the vehicle where it is stuck, or to secure it for recovery on a flatbed lorry or trailer.  
Towing constraints  
Type of vehicle  
(engine / gearbox)  
Front wheels on the  
ground  
Rear wheels on the  
ground  
Flatbed  
4 wheels on the ground  
with towbar  
Internal combustion / Manual  
Internal combustion / Automatic  
Hybrid 2WD  
Hybrid 4WD  
2WD: 2-wheel drive.  
4WD: 4-wheel drive.  
In case of battery or electric parking brake failure, it is essential to call a professional using flatbed recovery vehicles (excluding manual gearbox).  
216  
In the event of a breakdown  
Depending on version, the towing eye is stored  
either in the interior trim of the boot sill, left-hand  
side, or in a bag behind the left-hand rear seat.  
The towing eye is stored in a tool box, under the  
boot floor.  
Accessing the tools  
8
For more information on accessing the Tool kit,  
refer to the corresponding section.  
Towing your vehicle  
To access the front screw thread:  
Model with halogen headlamps  
► Press the indicated zone until the cover is  
unclipped.  
► Unclip the cover by pressing at its top left-  
hand corner.  
Model with Full LED technology headlamps  
► Press and hold the top right-hand corner,  
then slide your finger to the left until the cover  
unclips.  
To be towed:  
► Screw the towing eye in fully.  
► Install the towbar.  
► Put the gearbox into neutral.  
217  
In the event of a breakdown  
Failure to observe this instruction could  
result in damage to certain components  
(braking, transmission, etc.) and to the  
absence of braking assistance the next time  
the engine is started.  
► Install the towbar.  
► Switch on the hazard warning lamps on both  
vehicles.  
► Move off gently, drive slowly and only for a  
short distance.  
Automatic gearbox: never tow the vehicle  
with the driving wheels on the ground  
and the engine off.  
► Unlock the steering and release the parking  
brake.  
► Switch on the hazard warning lamps on both  
vehicles.  
► Unclip the cover by pressing at its left-hand  
section.  
► Pull the cover downwards.  
► Move off gently, drive slowly and only for a  
short distance.  
Towing another vehicle  
To access the rear screw thread:  
► Press the top left-hand corner of the cover,  
then press the bumper to the right of the cover  
until it unclips.  
To tow:  
► Screw the towing eye in fully.  
218