In the event of a breakdown
For more information on Refuelling and
on Misfuel prevention (Diesel), please
refer to the corresponding section.
Assembling and placing the
triangle
Warning triangle
As a safety precaution, before leaving your
vehicle to set up and install the triangle, switch
on the hazard warning lamps and put on your
high visibility vest.
For non-BlueHDi versions, the fuel system
components are located in the engine
compartment, possibly under the removable
cover.
Storage compartment
For more information on the Engine
compartment, in particular the location
of these components under the bonnet,
please refer to the corresponding section.
1.5 BlueHDi engines
► Switch on the ignition (without starting the
engine).
► Wait around 1 minute and switch off the
ignition.
► Operate the starter motor to start the engine.
If the engine does not start at the first attempt,
do not keep trying, but restart the procedure.
For versions supplied with a triangle as original
equipment, refer to the illustration above.
For other versions, refer to the assembly
instructions provided with the triangle.
► Put the triangle in place behind the vehicle,
as required by local legislation.
There is a compartment in the interior trim of the
tailgate to store a warning triangle.
► After opening the tailgate, release the cover
by turning the screw a quarter turn to the left.
2.0 BlueHDi engines
Running out of fuel
(Diesel)
With Diesel engines, the fuel system must be
primed if you run out of fuel.
► Switch on the ignition (without starting the
engine).
► Wait around 6 seconds and switch off the
ignition.
Before starting to prime the system, it is
essential to put at least 5 litres of Diesel into the
fuel tank.
► Repeat the operation 10 times.
► Operate the starter motor to start the engine.
If the engine does not start at the first attempt,
do not keep trying, but restart the procedure.
190
English