Get Safety -> Seat belts Guide for Peugeot 5008 SUV Third Generation (2024-2025)

Safety

in this case, the maintained descent speed is

lower.

In the event of an impact

Seat belts

Depending on the nature and seriousness

of the impacts, the pyrotechnic device may

trigger before and independently of airbag

deployment. Deployment of the pretensioners

is accompanied by a slight discharge of

harmless smoke and a noise, due to

the activation of the pyrotechnic cartridge

incorporated in the system.

In all cases, the airbag warning lamp comes

on.

Following an impact, have the seat belt

system checked, and if necessary replaced,

by a PEUGEOT dealer or a qualified

workshop.

Inertia reel

Activation of the system may cause noise

in the transmission. This is perfectly

normal and has no consequence on the

behaviour of the vehicle.

The seat belts are equipped with an inertia

reel which allows the strap length to adjust

automatically to the shape of the user. The seat

belt returns to its storage automatically when it is

not used.

The inertia reels are fitted with a device which

automatically locks the strap in the event of a

collision, emergency braking or if the vehicle

rolls over. It can be released by pulling the strap

firmly and then releasing it so that it reels in

slightly.

On a downward slope, with the vehicle

stationary, if the driver releases the accelerator

and brake pedals, the system will release the

brakes to set the vehicle gradually in motion.

The brake lamps light up automatically when the

system is regulating.

If the speed exceeds 19 mph (30 km/h),

regulation is paused automatically, the indicator

lamp goes back to grey in the instrument panel.

Regulation resumes automatically when the

speed falls below 19 mph (30 km/h) again, if the

slope and pedal release conditions are met.

The driver can depress the accelerator or brake

pedal again at any time.

Pyrotechnic pretensioning

This system improves safety in the event of a

frontal or side impact.

Depending on the severity of the impact,

the pyrotechnic pretensioning system instantly

tightens the seat belts against the body of the

occupants.

Front seat belts

Each of the front seats has a three-point seat

belt with inertia reel.

The front seat belts are fitted with a pyrotechnic

pretensioning system and a progressive force

limiting system.

The pyrotechnic pretensioning seat belts are

enabled when the ignition is on.

Malfunction

Force limiting system

Rear seat belts

In the event of a malfunction, this

warning lamp comes on in green on

the instrument panel, accompanied

by the display of a message.

This system reduces the pressure of the seat

belt on the chest of the occupant, thus improving

their protection.

Progressive force limiting system

Have it checked by a PEUGEOT dealer or a

qualified workshop.

This system reduces the pressure of the seat

belt on the chest of the occupant, taking

their stature into account, thus improving their

protection.

Safety

Front left seat belt indicator lamp

Front right seat belt indicator lamp

Each of the rear seats has a three-point seat belt

with inertia reel.

The outer seats are fitted with a pyrotechnic

pretensioning and force limiting system.

Seat belt not fastened/

unfastened alerts

Second row left seat belt indicator lamp

Second row centre seat belt indicator lamp

Second row right seat belt indicator lamp

Third row left seat belt indicator lamp

Third row right seat belt indicator lamp

Fastening

► Pull the strap, then insert the tongue into the

buckle.

Seat belts not fastened/unfastened

identification indicator lamps

► Check that the seat belt is fastened correctly

by pulling on the strap.

The red indicator lamps (1 to 5 or 7) on the

instrument panel indicate the location of the

seat belts which are not fastened or have been

unfastened.

Unfastening

Not fastened/unfastened warning lamp

► Press the red button on the buckle.

► Guide the seat belt as it is reeled in.

It comes on in red on the instrument

panel as soon as the system detects

that a seat belt is not fastened or has

been unfastened.

Third row seatbelts

In this case, the vehicle symbol containing the

belt indicator lamps for each seat also lights up

red.

Front seat belt not fastened alert

When the ignition is switched

on, if the driver or

front passenger has not

fastened their seat belt, the

corresponding indicator lamp (1 or 2) comes on

in red. At a speed greater than 12 mph (20

km/h), the warning lamp and the corresponding

indicator lamp flash red, accompanied by an

audible signal for around 2 minutes. After this

time has elapsed, the indicator lamp remains on

fixed in red until the seat belt is fastened.

Third row seatbelts are always visible and fixed.

Safety

Second row seat belt not fastened alert

Advice

Installation

The lower part of the strap must be

positioned as low as possible over the pelvis.

The upper part must be positioned in the

hollow of the shoulder.

At the front, adjusting the position of the

seat belt may require the seat height to be

adjusted.

In order to be effective, a seat belt must:

– be tightened as close to the body as

possible.

– be pulled in front of you with a smooth

movement, checking that it is not twisted.

– only be used to secure one person.

– not show signs of tearing or fraying.

– not be changed or modified, in order to

avoid affecting its performance.

When the ignition is switched on, if

one of the second row passengers

has not fastened their seat belt, the

corresponding indicator lamp (3, 4 or

5) comes on in red for 1 minute.

The driver must ensure that passengers

use the seat belts correctly and that they

are all fastened before setting off.

Wherever seated in the vehicle, you must

always fasten the seat belt, even for short

journeys.

Seat belt unfastened alert

After the ignition is switched

on, if the driver or a passenger

unfastens their seat belt, the

Do not invert the seat belt buckles, as they

will not fulfil their role properly.

To ensure the proper functioning of the belt

buckles, make sure that there are no foreign

bodies present (e.g. a coin) before fastening.

Before and after use, ensure that the seat belt

is reeled in correctly.

After folding or moving a seat or rear bench

seat, ensure that the seat belt is positioned

and reeled in correctly.

corresponding indicator lamp

(1, 2, 3, 4, 5, 6 or 7) comes on in red. At

a speed greater than 12 mph (20 km/h), the

warning lamp and the corresponding indicator

lamp flash, accompanied by an audible signal for

around 2 minutes. After this time has elapsed,

the indicator lamp remains on until the seat belt

has been fastened again.

Recommendations for children

Use a suitable child seat if the passenger

is less than 12 years old or shorter than 1.5

metres.

Never use the same seat belt to secure more

than one child.

Never carry a child on your lap.

For more information on Child seats, refer to

the corresponding section.

With the ignition on, if the driver or a

passenger fastens their seat belt, the

corresponding indicator lamp (1, 2, 3,

4, 5, 6 or 7) comes on in green on the

instrument panel.

With the ignition on, if one of the front

or rear passenger seats is detected as

being unoccupied, the corresponding

indicator lamp (2,3, 4, 5, 6 or 7) comes

on in grey on the instrument panel.

When there are no longer any

not fastened/unfastened alerts, the

warning lamp goes off and the green

or grey indicator lamps remain on for

around 30 seconds, then go off.

Download User Manual App

Safety -> Seat belts for Your Peugeot 5008 SUV Third Generation (2024-2025)

Related Topics

Safety

Popular Owner Manuals

Latest Owner Manuals