Access
Reinitialisation
electric windows
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
Automatic mode
F
Lower the window fully, then raise it, it will
rise in steps of a few centimetres each time
the control is pressed.
Press or pull the control, beyond the point of
resistance. The window opens or closes fully
when the control is released. Pressing the
control again stops the movement of the window.
The electrical functions of the electric windows
are deactivated:
F
F
Repeat the operation until the window is
fully closed.
Continue to press the control for at least
one second after the window closed
position has been reached.
-
approximately 45 seconds after the ignition
is switched off,
The safety anti-pinch does not operate
whilke doing this.
-
after one of the front doors is opened, if the
ignition is off.
1. Driver's electric window control
2. Passenger electric window control
Always remove the key when leaving
the vehicle, even for a short period.
If an electric windows meets an
obstacle during operation, you must
reverse the movement of the window.
To do this, press the control concerned.
When the driver operates the
passenger electric window controls,
they must ensure that no one is
preventing the correct closing of the
windows.
Safety anti-pinch
There are two operating modes:
If your vehicle is fitted with the safety anti-pinch
function, when the window rises and meets an
obstacle, it stops and partially lowers.
In the event of unwanted opening of the window
on closing, press the control until the window is
fully open. Within the next 4 seconds, pull the
control until the window is fully closed.
The safety anti-pinch does not operate while
doing this.
Manual mode
Press or pull the control, without passing the
point of resistance. The window stops when
you release the control.
The driver must ensure that passengers
use the electric windows correctly.
Be aware of children when operating
the windows.
86
English 