Ease of use and comfort -> Programmable Heating / Ventilation for Your Peugeot Traveller Van First Generation (2016-2026)

Ease of use and comfort  
Programmable Heating / Ventilation  
Programming  
Audio system  
3
F
Press on the MENU button to go  
to the main menu.  
F
Select:  
-
the 1st clock to programme/store your  
start time,  
-
the 2nd clock to programme/store a  
second start time.  
F
F
Select "Pre-heat. / Pre-ventil.".  
Heating  
Select "Activation" and if necessary for  
programming, select "Parameters".  
This is an additional and separate system  
which heats the engine hot water circuit to  
heat the passenger compartment and improve  
defrosting.  
F
Select "Heating" to heat the engine and  
passenger compartment or "Ventilation"  
to ventilate the passenger compartment.  
This indicator lamp is on when if the  
system is programmed to come on  
for heating.  
This indicator lamp flashes while the  
heating is operating.  
using these two clocks and according  
to season you can, for example, select  
one or the other start time.  
A message in the screen confirms your  
choice.  
Ventilation  
This system allows ventilation of the passenger  
compartment to improve the temperature  
experienced on entering the vehicle in summer.  
137  
Ease of use and comfort  
Long range remote  
control  
Do not throw the remote control  
batteries away, they contain metals  
which are harmful to the environment.  
Take them to an approved collection  
point.  
The indicator lamp in the remote control  
flashes for about 2 seconds if the  
vehicle has not received the signal.  
You should then move to a different  
location and repeat the command.  
The range of the remote control is about  
0.6 miles (1 km), in open country.  
Changing the battery  
During heating  
If the indicator lamp in the remote control becomes  
orange, the state of charge of the battery is low.  
If the indicator lamp is not on, the battery is  
discharged.  
This indicator lamp flashes while the  
heating is in operation.  
This indicator lamp goes off at the  
end of the heating cycle or when the  
heating is stopped using the remote  
control.  
Switching on  
F
Press and hold this button to  
start the heating immediately.  
The maximum heating period is about  
45 minutes depending on the ambient  
conditions.  
The indicator lamp in the remote control comes  
on in green for about 2 seconds to confirm that  
the signal has been received by the vehicle.  
Switching off  
F
Press and hold this button to stop  
the heating immediately.  
F
use a coin to unscrew the cap and replace  
the bulb.  
The indicator lamp in the remote control comes  
on in red for about 2 seconds to confirm that  
the signal has been received by the vehicle.  
138  
Ease of use and comfort  
The programmable heating system is  
supplied by the vehicle's fuel tank.  
Before use, ensure that there is enough  
fuel in the tank.  
If the tank is on reserve, it is  
recommended that the system is not  
used.  
Always switch off the programmable  
heating while refuelling to avoid any risk  
of fire or explosion.  
3
To avoid the risk of intoxication and  
asphyxiation, the programmable  
heating must not be used, even for  
short periods, in an enclosed area such  
as a garage or workshop not equipped  
with exhaust gas extraction.  
The ventilation is activated provided  
that the battery is sufficiently charged.  
The heating is activated provided that:  
-
-
-
the battery is sufficiently charged,  
the fuel level is adequate,  
the engine has been started since  
the previous heating cycle.  
Do not park the vehicle on an  
inflammable surface (dry grass, dead  
leaves, paper…), there is a risk of fire.  
glazed surfaces such as the rear  
screen or windscreen can become very  
hot in places.  
Take care not to place objects in  
contact with these surfaces, nor touch  
them with your hands or any other part  
of your body.  
139