Ease of use and comfort -> Front seats (manual/electric) for Your Peugeot Traveller Van First Generation (2016-2026)

Ease of use and comfort  
Steering wheel adjustment Front seats with manual adjustments  
As a safety measure, seat adjustments should only be carried out when stationary.  
Forwards-backwards  
Height  
3
F
When stationary, lower the control lever  
to release the steering wheel adjustment  
mechanism.  
F
F
Adjust the height and reach to suit your  
driving position.  
Pull the control lever to lock the steering  
wheel adjustment mechanism.  
As a safety precaution, these  
operations should only be carried out  
while the vehicle is stationary.  
F
Raise the control and slide the seat  
forwards or backwards.  
F
If fitted to your vehicle, pull the control  
upwards to raise or push it downwards to  
lower, as many times as required to obtain  
the position required.  
Before moving the seat backwards, ensure that there is nothing that might prevent the full  
travel of the seat, so as to avoid the risk of jamming the seat caused by the presence of  
objects on the floor behind the seat or rear passengers. If the seat jams, stop the movement  
immediately.  
87  
Ease of use and comfort  
Backrest angle  
Lumbar  
F
Turn the knob to adjust the backrest.  
F
Pull the control fully up and move the  
backrest forward or backward.  
F
Turn the knob manually to obtain the  
desired level of lumbar support.  
For more information on the Seat belts,  
refer to the corresponding section.  
88  
Ease of use and comfort  
Table position for the driver's  
and/or the front passenger's seat  
backrest  
on the front passenger's side, this position  
allows long objects to be carried.  
on the driver's side, this position allows rear  
passengers to be helped out of the vehicle  
(by the emergency services).  
3
Check that there is no object that could  
interfere with the movement of a seat,  
both above and below.  
F
Place the head restraint in the low position,  
and if fitted to your vehicle, raise the  
armrest and fold the table on the back of  
the seat.  
F
Pull the control fully up and tip the backrest  
forward.  
To return to the normal position, pull the  
control up to release the backrest, then pull the  
backrest up to its raised position.  
89  
Ease of use and comfort  
Height  
electric front seat  
Forwards-backwards  
Backrest angle  
F
Tilt the control upwards or downwards to  
obtain the desired height.  
F
Push the control forwards or rearwards to  
slide the seat.  
F
Tilt the control forwards or rearwards to  
adjust the angle of the seat backrest.  
For more information on the Seat belts,  
refer to the corresponding section.  
Before moving the seat backwards, ensure that there is nothing that might prevent the full  
travel of the seat, so as to avoid the risk of jamming the seat caused by the presence of  
objects on the floor behind the seat or rear passengers. If the seat jams, stop the movement  
immediately.  
To avoid discharging the battery, carry out  
these adjustments with the engine running.  
90  
Ease of use and comfort  
Additional adjustments  
Head restraint height  
adjustment  
Heated seats control  
The head restraint rods have notches  
which prevent the head restraint  
lowering; this is a safety device in case  
of impact.  
The adjustment is correct when the  
upper edge of the head restraint is  
level with the top of the head.  
Never drive with the head restraints  
removed; they must be in place and  
adjusted correctly.  
With the engine running, the front seats can be  
heated separately.  
3
Armrest  
F
use the adjustment wheel to switch on and  
select the level of heating required:  
If fitted to your vehicle.  
0: off.  
F
F
To raise the head restraint, pull it upwards.  
To remove the head restraint, press the  
lug A and pull the head restraint upwards.  
To put the head restraint back in place,  
engage the head restraint rods in the  
apertures keeping them in line with the  
seat backrest.  
1: Low.  
2: Medium.  
3: High.  
F
F
The armrest has notched positions.  
F
F
F
Raise the armrest fully up.  
Lower it fully down.  
Raise the armrest to the desired position.  
To lower the head restraint, press the lug A  
and the head restraint at the same time.  
91  
Ease of use and comfort  
Electric lumbar adjustment  
Massage function  
Deactivation  
You can deactivate the massage  
function at any time by pressing this  
button, its indicator lamp goes off.  
Adjustment of intensity  
F
Press the control to obtain the desired  
lumbar support.  
This system provides the occupants of the  
front seats with a lumbar massage. It only  
operates when the engine is running or in  
SToP mode of the Stop & Start system.  
Activation  
F
Press this button.  
Press this button to adjust the  
intensity of the massage.  
Two levels of massage are available.  
Its indicator lamp comes on and the massage  
function is activated for a period of 1 hour.  
During this time, massage is performed in  
6 cycles of 10 minutes (6 minutes of massage  
followed by 4 minutes break).  
After one hour, the function is deactivated, the  
indicator lamp goes off.  
92