Get Getting to know your vehicle -> Exterior lighting and signals Guide for Renault Scenic 4 Door Fourth Generation (2017-2022)

EXTERIOR LIGHTING AND SIGNALS (1/6)

1

Dipped beam

headlights

1

k

2

Manual operation

Turn ring 3 until the symbol is opposite

mark 2. This indicator light on the in-

strument panel comes on.

Automatic operation

Turn ring 3 until theAUTO symbol is op-

posite mark 2: with the engine running,

the dipped beam headlights switch on

or off automatically depending on the

brightness of the light outside, without

any action on stalk 1.

3

Side lights

Turn ring 3 until the symbol is

opposite mark 2. This indicator light on

the instrument panel comes on.

Main beam headlights

With the dipped beam

headlights lit, push stalk 1. This indica-

tor light on the instrument panel comes

on.

š

á

To return to the dipped headlight posi-

tion, pull the stalk 1 towards you again.

Before driving at night: check that the electrical equipment is operat-

ing correctly and adjust your headlights. Refer to the information on

“Adjusting the headlight beams” in section 1. As a general precaution,

check that the lights are not obscured (by dirt, mud, snow or objects

being transported).

1.98

EXTERIOR LIGHTING AND SIGNALS (2/6)

Automatic main beam

headlights



4

Depending on the vehicle, this system

switches the main beam headlights on

and off automatically. It uses a camera

located behind the interior rear-view

mirror to detect vehicles that are being

followed and those coming in the oppo-

site direction.

The main beam headlights come on au-

tomatically if:

– exterior light is weak;

– no other vehicles or lighting are de-

tected;

– the vehicle speed is above approxi-

mately 25 mph (40 km/h).

Switching on

If any of the above conditions are not

fulfilled, the system switches to dipped

beam headlights.

Vehicle fitted with a navigation

system

From the multimedia screen, 4, select

the “Vehicle” menu, “Driving assist-

ance”, “Automaticmain beam lights”,

then choose “ON” or “OFF”.

The system may encounter difficul-

ties under certain conditions, inclu-

ding:

– extreme weather conditions (rain,

snow, fog, etc.);

– obstruction in front of the wind-

screen or camera;

The “automatic main beam

headlights” system should

under no circumstances be

– when a following or oncoming ve-

hicle has weak or hidden lighting;

– incorrect settings for the front

headlights;

used to replace driver atten-

tion and responsibility with regard

to vehicle lighting and adapting to

light, visibility and traffic conditions.

– reflective systems;

– ...

1.99

EXTERIOR LIGHTING AND SIGNALS (3/6)

– repeatedly press control 6 up or down

until you reach the “Automaticmain

beam lights” menu, then press the

OK switch 5;

1

2

– press the OK switch 5 again to acti-

5

vate or deactivate the function.

6

Activation/deactivation

To activate automatic main beam

headlights:

– turn ring 3 until the AUTO symbol is

opposite mark 2;

3

– push stalk 1.

Vehicles without a navigation

system

To deactivate automatic main beam

headlights:

Warning light

strument panel.



comes on the in-

– With the vehicle stationary, press

and hold the OK switch 5 to access

the settings menu;

– pull stalk 1 towards you;

– or turn ring 3 to a position other than

AUTO.

– repeatedly press the control 6 up

or down until you reach the “Driving

assistance” menu. Press the OK

switch 5;

Warning light

strument panel.



goes out on the in-

Note: make sure the windscreen is not

obscured (dirt, mud, snow, condensa-

tion etc.).

Each time you start the engine, pull

and then push the stalk 1 to reacti-

vate the system.

1.100

EXTERIOR LIGHTING AND SIGNALS (4/6)

Automatic main beam



Operating faults

When the message “Check lighting”

headlights (continued)

Operating faults

1

and warning light

^{with warning light}k^{© is displayed}

flashes on the

When the message “Check auto li-

ghting” appears on the instrument

panel, the system is deactivated.

Consult an approved dealer.

instrument panel, this indicates that

there is a lighting fault.

Consult an approved dealer.

Switching off the lights

There are two possibilities:

– manually, move ring 3 to position 0;

– automatically, the lights will go out

when the engine is switched off, the

driver’s door is opened or the vehicle

is locked. In this case, the next time

the engine is started the lights will be

switched back on according to the

position of the ring 3.

3

Daytime running lights

function

The daytime running lights come on

automatically with no action on stalk 1

when the engine is started, and they go

off once the engine is switched off.

Lights-on reminder buzzer

A warning beep sounds when the driv-

er’s door is opened to warn you that the

lights are still on.

Using the portable naviga-

tion system at night in the

windscreen area below the

camera may disturb the op-

eration of the “automatic main beam

headlights” system (risk of reflection

on the windscreen).

1.101

EXTERIOR LIGHTING AND SIGNALS (5/6)

Welcome lighting under the door

mirrors

“See-me-home lighting”

function

This function allows you to briefly switch

on the dipped beam headlights (to pro-

vide light when opening a gate, etc.).

Welcome and goodbye

function

(depending on the vehicle)

With the function activated, the lights

located under the door mirrors come

on automatically upon detection of the

RENAULT card, upon unlocking the

vehicle or when opening a door.

Once the function is activated, the day-

time running lights and the rear side

light light up automatically upon detect-

ing the RENAULT card or when the ve-

hicle is unlocked.

With the engine and lights switched

off and the ring 3 in position 0 or

AUTO, pull the stalk 1 towards you: the

dipped beam headlights come on for

approximately 30 seconds. To increase

this duration, you may pull the stalk up

to four times (total time restricted to ap-

proximately two minutes). The mes-

sage “Follow-me home for _ _ _” along

with the time the lights will be on for is

displayed on the instrument panel to

confirm this action. You can then lock

your vehicle.

They switch off automatically:

– approximately one minute after li-

ghting up;

– approximately one minute after li-

ghting up;

– upon starting the engine;

or

– when starting the engine based on

the position of the lighting stalk;

– upon locking the vehicle.

or

Activating/deactivating the function

– upon locking the vehicle.

From the multimedia screen, select

“Vehicle”, “User settings”, “External

welcome”. Choose “ON” or "OFF” to

activate or deactivate the function.

To switch off the lights before they go

out automatically, turn ring 3 to any po-

sition, then return it to the AUTO posi-

tion .

1.102

EXTERIOR LIGHTING AND SIGNALS (6/6)

Rear fog lights

Turn centre ring 7 on the stalk

until the symbol faces mark 2, then re-

Switching off the lights

1



lease it.

Turn the ring 7 again until the mark 2

is opposite the symbol for the fog light

that you wish to switch off. The corre-

sponding indicator light on the instru-

ment panel goes out.

2

Operation of the fog lights depends on

the exterior lighting selected, and an in-

dicator light will light up on the instru-

ment panel.

The fog lights switch off when the exte-

rior lights are switched off.

Do not forget to switch off the fog lights

when they are no longer needed, to

avoid inconveniencing other road

users.

Cornering lights

(depending on vehicle)

7

Whenever the dipped beam headlights

are on and under certain conditions (at

speed, the steering wheel at an angle,

in forward gear, the indicator lights on,

etc.), when taking a corner one of the

front fog lights will come on to light the

inside of the bend.

Front fog lights

Turn centre ring 7 on stalk 1

until the symbol faces mark 2, then re-

g

lease it.

Operation of the fog lights depends on

the exterior lighting position selected,

and an indicator light will light up on the

instrument panel.

When driving in fog or snow, or

when transporting objects which are

higher than the roof, the headlights

do not come on automatically.

Switching on the fog lights remains

the responsibility of the driver: the

indicator lights on the instrument

panel inform you whether the fog

lights are lit (indicator light on) or not

(indicator light not on).

1.103

Getting to know your vehicle -> Exterior lighting and signals for Your Renault Scenic 4 Door Fourth Generation (2017-2022)

Related Topics

Popular Owner Manuals

Latest Owner Manuals