“AUTOHOLD” FUNCTION
Vehicle stopped (e.g. at a red light, an
intersection, a traffic jam, etc.), the func-
tion ensures braking force even when
the driver releases the brake pedal.
The braking force is released as soon
as the driver accelerates sufficiently
with a gear engaged.
Conditions for interrupting the
braking force
The following conditions must be met:
– the driver accelerates sufficiently
with a gear engaged;
or
– the driver disables the function.
Warning light
strument panel.
goes out on the in-
1
Activation
Press switch 2.
The switch warning light 2 illuminates
to confirm that the function is activated.
2
Deactivation
Conditions for maintaining the
braking force
Press the brake pedal and 2 switchsi-
multaneously.
The switch warning light 2 turns off,
confirming that the function is deacti-
vated.
If the braking force is maintained, the
parking brake is applied automatically
when:
– the driver exits the vehicle;
or
– the vehicle is immobilised for more
than approximately three minutes.
The following conditions must be met:
– the seat belt for the driver is fas-
tened;
and
– the electronic parking brake is re-
leased;
and
Upon each start-up, the function
continues the mode set at the time
the engine was last switched off.
Before leaving the vehicle,
check that the electronic
parking brake is fully ap-
plied. The indicator light on
– the vehicle is not stationary on a very
steep slope.
firmed by the
the instrument panel.
The maintained braking force is con-
warning light on
switch 1 and the warning light
}
on the instrument panel illuminate to
show that the parking brake is ap-
plied and switch off when the doors
are locked.
2.62
English 
