Get Driving -> Tyre pressure monitor Guide for Renault Zoe 4 Door Third Generation (2019-2024)

TYRE PRESSURE MONITOR (1/5)

Resetting the standard level

Resetting procedure

1

for the tyre pressures

Ignition on, vehicle stopped:

– Repeatedly tap switch 5 as many

times as necessary to reach the ve-

hicle tab;

– tap switch 2 or switch 3 to access

the tyre pressures reset page. The

message “SET tyre pressure (press

and hold)” appears on the instrument

panel;

– press and hold the 4 OK switch to

launch the reset. The flashing tyres

symbol followed by the message

“Learning Tyre Pressures” indicates

that the reset request for the tyre

pressure has been acknowledged.

This should be done:

– when the standard tyre pressure

needs to be changed to adapt to

usage conditions (empty, carrying a

load, motorway driving, etc.);

– after swapping a wheel (however

this practice is not recommended);

– after changing a wheel.

5

2

It should always be done after checking

the tyre pressure of all four tyres when

cold.

4

3

Tyre pressures must correspond to the

current usage of the vehicle (empty,

carrying a load, motorway driving, etc.).

If the vehicle is equipped with the func-

tion, this system monitors the tyre pres-

sure.

Reset can take several minutes of driv-

ing.

Note: the standard tyre pressure

cannot be less than that recommended

and indicated on the door frame.

Operating principle

Each wheel (except for the emergency

spare wheel) has a sensor in the infla-

tion valve which periodically measures

the tyre pressure.

The system displays the current pres-

sures on the instrument panel 1 and

alerts the driver in the event of insuffi-

cient pressure.

Resetting can also be performed

from the multimedia screen. Select

“Vehicle”, “Tyre pressure”.

2.18

TYRE PRESSURE MONITOR (2/5)

The table below shows the possible messages related to the tyre resetting procedure.

Steps

Displays

Messages

Readings

(depending on

the vehicle)

1

Tyre pressure init. long press With the ignition on and the vehicle stationary, start the

resetting the pressure of all four tyres by pressing and

holding the 4 OK switch.

2

3

Learning Tyre Pressures

Tyre detection in progress

The “---” quote marks in front of each wheel will flash to

indicate that the system has registered the tyre pressure

reset for all four wheels.

The “---” quote marks in front of each wheel will remain

lit. This system resets the tyre pressure of all four tyres.

You can now drive. The message may remain displayed

during short journeys.

Note: during the reset, tyre pressure monitoring remains

in operation.

4

The pressure value of the four tyres is displayed: the re-

setting procedure is complete and successful.

2.19

TYRE PRESSURE MONITOR (3/5)

“Adjust tyre pressure”

A yellow wheel appears accompanied

“Puncture”

A red wheel appears accompanied by

by a fixed 6 warning light and the

a fixed 6



warning light and the

message “Adjust Tyre Pressure”.

They indicate that a wheel is deflated.

Check and, if necessary, readjust the

message “Puncture” as well as a sound

signal.

This message appears along with the

A

^{pressures of the fou}^{r wheels when cold.}

goes off after

®warning light.

They indicate that the affected wheel

is punctured or severely underinflated.

Replace it or contact an approved

dealer if it is punctured. Top up the tyre

pressure if the wheel is deflated.

The warning light 6

a few minutes’ driving.

“Check tyre pressure sensors”

6

^{The wh}^{eel disappears and the warning}

flashes for several sec-

Display

The display A and the warning light 6

light 6

onds before staying on and the mes-

sage “Check Tyre Pressure Sensors”

appears.



on the instrument panel warn

you of any tyre pressure faults (flat tyre,

punctured tyre, system fault, etc.).

This message appears along with the

that at least one wheel is not fitted

with sensors (e.g. emergency spare

wheel). Otherwise, consult an author-

ised dealer.

For your safety, the warning

^light® requires you

to stop immediately as soon

as traffic conditions allow.

The sudden loss of pressure in a

tyre (burst tyre, etc.) cannot be de-

tected by the system.

2.20

TYRE PRESSURE MONITOR (4/5)

“Tyre location failure”

Replacing wheels/tyres

This system requires specific equip-

ment (wheels, tyres, hubcaps, etc.).

➥ 5.6.

Contact an approved Dealer to fit new

tyres and to find out about available ac-

cessories compatible with the system

and available from your dealer net-

work: the use of any other accessory

could affect the correct operation of the

system or damage a sensor.

Tyre repair product and

inflation kit

As the valves are specifically designed,

only use equipment approved by the

approved network. ➥ 5.3.

The message “Failure to detect tyres”

appears during driving if one or more

wheels have been fitted with sensors

not recognised by the network.

Consult an approved dealer

Readjustment of tyre

pressures

The pressures must be adjusted

when the tyres are cold ➥ 4.9. If

the tyre pressures cannot be checked

when the tyres are cold, the recom-

mended pressures should be increased

by 0.2 to 0.3 bar (3 PSI).

Emergency spare wheel

If the vehicle is equipped with an emer-

gency spare wheel, it will not have a

sensor. If the vehicle is fitted with one,

Never deflate a hot tyre.

the warning light 6



flashes for

several seconds then comes on con-

ing light, and the message “Check Tyre

Pressure Sensors” appears on the in-

strument panel.

This function is an addi-

tional driving aid.

However, the function is

not intended to replace the

driver. It cannot, therefore, under

any circumstances replace the vig-

ilance or the responsibility of the

driver. Check the tyre pressures, in-

cluding the emergency spare wheel,

once a month.

2.21

TYRE PRESSURE MONITOR (5/5)

The information on the instrument panel signals any potential tyre pressure faults (e.g. deflated or punctured tyre). For

^{your safety, the warning light}® requires you to stop immediately as soon as traffic conditions allow.

Indicator

lights

Messages

Displays

Readings

The wheel and associated pressure value are dis-

played in yellow.

This indicates that tyre under-inflation has been de-

tected. Check and adjust the pressure of the four

tyres then reset the system.

Adjust Tyre Pressure



The wheel and associated pressure value are dis-

played in red.

This indicates that the tyre concerned is punctured

or severely underinflated. Adjust the pressure of the

four tyres while cold and reset the system if the tyre

is deflated. Replace the tyre (or have it replaced) if

it is punctured.

Puncture



+ ®

A wheel is no longer displayed.

This indicates that at least one wheel is not fitted with

a sensor (e.g. emergency spare wheel) or that the

sensor is faulty. Consult an approved dealer.

Check Tyre Pressure Sensors

Failure to detect tyres



+ ©

This indicates that the system has not been able to

determine the pressure of each tyre. This may be

caused by the use of a sensor not recommended by

an approved dealer. The tyre pressure sensor moni-

toring system remains in operation.



2.22

Driving -> Tyre pressure monitor for Your Renault Zoe 4 Door Third Generation (2019-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals