Get Driving -> Lane Keeping Assist Guide for Renault Zoe 4 Door Third Generation (2019-2024)

LANE KEEPING ASSIST (1/5)

1

Note: make sure the windscreen is not

obscured (dirt, mud, snow, condensa-

tion etc.).

Using information from the 1 camera,

the function triggers corrective action

on the vehicle steering system when

a continuous or broken line is crossed

or when approaching the roadside (di-

vider, barrier, pavement, embankment,

etc.) without the direction indicator

lights being activated.

This function is an addi-

tional driving aid. This func-

tion is not under any circum-

stances intended to replace

the due care and attention of the

driver, who should at all times be

in control of the vehicle.

You can retake control of the ve-

hicle at any time by operating the

steering wheel.

2.39

LANE KEEPING ASSIST (2/5)

To disable the function, press the 2

switch as many times as required to

select “Lane Keeping deactivated” on

the instrument panel.

Warning light

strument panel.



goes out on the in-

Note: deactivating the “Lane Keeping

Assist” function causes deactivation of

the “Lane Departure Warning” function.

2

Activation/deactivation

To activate the function, press the 2

switch as many times as required to

select “Lane Keeping Assist” on the in-

strument panel.

and “

^{The “}^{Lane Keeping activated” message}

” warning light are displayed

on the instrument panel.

When Lane Keeping Assist is activated,

the “Lane Departure Warning” function

is automatically activated. ➥ 2.35.

Each time the vehicle is started,

the function continues the mode

saved the last time the engine was

stopped.

2.40

LANE KEEPING ASSIST (3/5)

In these cases:

Special case

– the function triggers an action on the

vehicle’s steering system to correct

the vehicle trajectory;

If the system no longer detects any

wheel, the

^{action by t}^{he driver on the steering}

warning light illumi-

nates in yellow on the instrument panel,

accompanied by the message: “Keep

hands on steering wheel” and a beep.

– the warning light



and the indi-

cator 3 on the side of the breached

line turns to yellow on the instrument

panel.

3

The beep sounds together with the

warning light and the message until the

driver takes control.

Note: on bends, the function allows for

slightly cutting the bend.

ing system is not sufficient, the

^{If the corrective action on the}^steer-

warning light and 3 indicator on the side

of the breached line turn to red on the

instrument panel, accompanied by a vi-

bration on the steering wheel.

Operation

When the function is activated, the



warning light and the left and

right lines 3 are displayed in grey on the

instrument panel.

The function is set to operate when

the vehicle speed is between approxi-

mately 43 mph (70 km/h) and 112 mph

(180 km/h) and if the

light and 3 correction indicators are col-

oured white.



warning

The function operates if the vehicle

breaches a line or if the vehicle ap-

proaches the roadside (divider, barrier,

pavement, embankment, etc.) without

the direction indicator lights being ac-

tivated.

You can interrupt the trajectory cor-

rection at any time by moving the

steering wheel.

2.41

LANE KEEPING ASSIST (4/5)

Temporarily not available

– Very fast lane departure;

Adjustment

With the vehicle stationary, engine run-

ning, from the multimedia screen 4

select the “Settings” menu, “Vehicle”

tab, the “Driving assistance” menu,

then “Lane”:

– driving continuously on a line;

4

– four seconds approximately after

changing lanes;

– “Vibration”: adjust steering wheel

vibration for the “Lane Departure

Warning” function;

– tight bends;

– impaired visibility;

– “Alert”: adjust the sensitivity level for

line detection. To do this, select:

– “Late”: line detected when cross-

ing;

– activation of one of the direction indi-

cator lights;

– strong acceleration;

– emergency braking;

– ...

– “Standard”: line detected on ap-

proach;

– “Early”: line detected nearby.

Conditions for non-activation

of the system

The system cannot be activated when:

– reverse gear is engaged;

– the field of vision of the camera is ob-

structed;

^{– the}® warning light is displayed.

Please refer to the multimedia instruc-

tions for further information.

If the function is unavailable, the



warning light and the left/right correc-

tion warning lights 3 appear in grey on

the instrument panel.

Operating faults

When the system detects an operating

on the instrument panel, with the mes-

sage “Front camera to check”.

The



warning light and the left/

right line warning lights are displayed in

grey on the instrument panel.

Consult an approved dealer.

2.42

LANE KEEPING ASSIST (5/5)

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care

and attention of the driver, who should at all times be in control of the vehicle.

System servicing/repairs

– In the event of an impact, the camera alignment may be changed, and its operation may consequently be affected. Deactivate

the function and consult an authorised dealer.

– Any work in the area where the camera is located (repairs, replacements, windscreen modifications etc.) must be carried

out by a qualified professional.

Only an authorised dealer is qualified to service the system.

In the event of system disturbance

Some conditions can disturb or damage the operation of the system, such as:

– windscreen obscured (by dirt, ice, snow, condensation etc.);

– a complex environment (tunnel etc.);

– poor weather conditions (snow, hail, black ice, rain, etc.);

– poor visibility (night, fog etc.);

– the road markings are irregular or difficult to distinguish (e.g. partially erased, excessive spacing, distorted road surface);

– being dazzled (glaring sun, lights of vehicles travelling in the opposite direction etc.);

– the road is narrow, winding or undulating (tight bends etc.);

– closely following a vehicle travelling in the same lane.

In this case, the “Lane Keeping Assist” may react incorrectly or not at all.

Risk of unwanted, incorrect correction or no correction of trajectory.

Deactivating the function

You must disable the function if:

– the area of the camera has been damaged (on the windscreen side or the interior rear-view mirror side);

– the road is slippery (snow, black ice, aquaplaning, gravel etc.) ;

– poor visibility (night, fog etc.);

– the windscreen is cracked or distorted (do not carry out windscreen repairs in this area; have it changed by an Authorised

Dealer);

– the vehicle is towing a trailer or a caravan;

– the vehicle is entering an area with several surface markings (an area with road works etc.).

2.43

Driving -> Lane Keeping Assist for Your Renault Zoe 4 Door Third Generation (2019-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals