Get Driving -> Parking distance control Guide for Renault Zoe 4 Door Third Generation (2019-2024)

PARKING DISTANCE CONTROL (1/7)

Depending on the vehicle, the system

detects obstacles to the front, the rear

and the sides of the vehicle.

The parking distance control system

is only activated when the vehicle is

driven at a speed below approximately

6 mph (10 km/h).

1

This measurement is indicated by

beeps which become more frequent the

closer you come to the obstacle, until

they become a continuous beep when

the vehicle is approximately 20 to

30 centimetres from the obstacle.

This function is an addi-

tional driving aid.

Location of the ultrasonic

sensors 1

Under no circumstances

should it replace the driv-

er’s care or responsibility whilst re-

versing.

Operating principle

Ultrasonic sensors, indicated by

arrows 1, are fitted in the bumpers to

measure the distance between the ve-

hicle and an obstacle.

Ensure that the ultrasonic sensors indi-

cated by the arrows 1 are not obscured

(by dirt, mud, snow, a badly fitted/at-

tached number plate, etc.), impacted,

modified (including paintwork) or ob-

structed by any accessory fitted to the

rear and/or, depending on the vehicle,

to the front or sides of your vehicle.

The driver should always be ready

for sudden incidents while driv-

ing: always ensure that there are

no small, narrow moving obstacles

(such as a child, animal, pushchair,

bicycle, stone, post, etc.) in the blind

spot when manoeuvring.

2.63

PARKING DISTANCE CONTROL (2/7)

Note: in the event of a change in tra-

jectory during a manoeuvre, the risk of

collision with an obstacles may be sig-

nalled late.

2

C

A

B

Vehicle fitted with a navigation

system

Operation

Most objects located less near the

front, rear and sides of the vehicle are

detected.

Note: the display 2 shows the vehicle

surroundings and emits beeps.

It is necessary to travel a few metres

before the side detection is activated.

If all areas have a grey background, the

whole area around the vehicle is being

monitored:

– A: analysis of the vehicle surround-

ings in progress;

– B: analysis of the vehicle surround-

ings carried out.

An impact to the under-

side of the vehicle while

manoeuvring (e.g. strik-

ing a post, raised kerb or

other street furniture) may result in

damage to the vehicle (e.g. defor-

mation of an axle).

Depending on the distance of the ob-

stacle, the frequency of the beep will

be higher while approaching it, and

will become a continuous beep around

20 cm away for obstacles to the sides,

and around 30 cm for obstacles to the

front or rear. Depending on the vehicle,

the green, orange (or yellow depending

on the vehicle) and red zones will be

displayed on the C display.

To avoid any risk of accident, have

your vehicle checked by an ap-

proved dealer.

2.64

PARKING DISTANCE CONTROL (3/7)

If a side obstacle is detected:

D

– the beeps become faster and then

sound continuously as the obstacle

gets nearer. Green, orange and red

zones will be displayed on the dis-

play D;

– if there is no risk of collision, no beep

will sound when approaching the ob-

stacle. Green, orange and red zones

will be displayed interspersed on the

display D.

3

Note: in the event of a change in tra-

jectory during a manoeuvre, the risk of

collision with an obstacle may be sig-

nalled late.

Detection of obstacles to the side

(depending on the vehicle)

Depending on the direction of the

wheels, the system determines the tra-

jectory of the vehicle and notifies the

driver of any risk or otherwise of a col-

lision with an obstacle 3 to the side of

the vehicle.

An impact to the under-

side of the vehicle while

manoeuvring (e.g. strik-

ing a post, raised kerb or

other street furniture) may result in

damage to the vehicle (e.g. defor-

mation of an axle).

To avoid any risk of accident, have

your vehicle checked by an ap-

proved Dealer.

2.65

PARKING DISTANCE CONTROL (4/7)

4

Setting on vehicles not fitted

with a navigation system

Depending on the vehicle, with the ve-

hicle stationary, engine running, some

settings can be adjusted from the multi-

media screen 4.

Please refer to the multimedia instruc-

tions for further information.

Select “Settings”, “Parking assistance”.

5

Parking distance control audio

volume

Select “Settings”, “Parking assistance”,

“Sound”. Adjust the volume of Park

Assist by pressing “+” or “-”.

Vehicles without a navigation

system

Activation/deactivation

Vehicle fitted with a navigation

system

With the vehicle stationary and the

engine running, press switch 5 to acti-

vate or deactivate the function.

With the vehicle stationary and the

engine running, from the multimedia

screen 4, select the “Settings” menu,

select the “Vehicle” tab, select the

“Parking assistance” menu then select

“ON” or “OFF” to activate or deactivate

areas covered by the ultrasonic sen-

sors.

2.66

PARKING DISTANCE CONTROL (5/7)

Setting on vehicles fitted

with a navigation system

(continued)

Parking distance control

automatic deactivation

The system deactivates:

Operating faults

If the system detects an operating fault,

a beep sounds for approximately three

seconds each time the reverse gear is

selected and the message “Check park-

ing distance control” appears on the in-

strument panel. Check that your ultra-

sonic sensors are clean. If the message

remains, contact an approved dealer.

– when the vehicle speed is above ap-

proximately 6 mph (10 km/h);

System sound

Enables the system sound to be

chosen. Select “Settings”, “Parking as-

sistance”, “Sound”.

– depending on the model, when the

vehicle is stationary for more than

approximately 5 seconds and an ob-

stacle is detected (such as when in a

traffic jam, etc.);

Deactivating the system sound

Activate or deactivate the parking dis-

tance control sound.

– when you are in position N;

– when an operating fault is detected.

Note: if you deactivate the sound, you

will no longer be notified with beeps

when approaching an obstacle.

An impact to the under-

side of the vehicle while

manoeuvring (e.g. strik-

ing a post, raised kerb or

other street furniture) may result in

damage to the vehicle (e.g. defor-

mation of an axle).

To avoid any risk of accident, have

your vehicle checked by an ap-

proved dealer.

When the vehicle is travelling at a

speed below approximately 6 mph

(10 km/h), some noises (motorcy-

cle, lorry, pneumatic drill etc.) may

trigger the beeping sound of the

parking distance control.

2.67

PARKING DISTANCE CONTROL (6/7)

System servicing/repairs

– In the event of an impact, the alignment of the sensors may be altered and their operation may consequently be affected.

Deactivate the function and consult an authorised dealer.

– Any work in the area where the sensors are located (repairs, replacements, etc.) must be carried out by a qualified profes-

sional.

Only an authorised dealer is qualified to service the system.

System disturbance

Some conditions can disrupt or damage the operation of the system, for example:

– poor weather conditions (rain, snow, hail, black ice, etc.);

– in the event of exposure to strong electromagnetic waves (under high-voltage lines, etc.);

– some types of noise (motorcycle, lorry, pneumatic drill, etc.).

Risk of false alarms or absence of warnings

In the event of the system behaving abnormally, deactivate it and consult an authorised dealer.

2.68

PARKING DISTANCE CONTROL (7/7)

Limitation of the system operation

– The area around the sensors must be kept clean and free of any modifications in order to ensure the proper operation of the

system.

– Small objects moving close to the vehicle (motorcycles, bicycles, pedestrians, etc.) may not be recognised by the system.

– The system may not detect objects that are too close to the vehicle.

– The system may not provide a warning when the other vehicles or objects are travelling at a significantly different speed.

– During a change in trajectory, during a manoeuvre, the system may report obstacles with a delay.

Deactivating the function

You must disable the function if the sensor area has been damaged (rear bumper).

2.69

Driving -> Parking distance control for Your Renault Zoe 4 Door Third Generation (2019-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals