Get Operation -> Anti-theft alarm system Guide for Seat Leon 4 Door Fourth Generation (2021-2026)

Opening and closing

●

Keyless Exit: locking the vehicle using the

Open the door.

Unlocking and locking the boot hatch

sensor of the driver or passenger door han-

dle.

When the vehicle is locked, the rear lid auto-

matically unlocks on opening if there is a val-

On vehicles with selective opening or info-

tainment system configuration, pulling the

door handle twice will unlock all doors.

●

Easy Open: opening the rear lid moving one

foot below the rear bumper page 112.

id vehicle key in the proximity zone Fig. 88.

›››

Open or close the rear lid normally.

●

Press & Drive: keyless starting of the engine

In vehicles without the “Safe” security sys-

tem: closing and locking the doors

(Keyless-Exit)

After closing, the hatch locks automatically. If

the complete vehicle is unlocked, the rear lid

will not lock automatically after closing it.

with the starter button page 216.

›››

The central locking and locking systems op-

erate in the same way as a normal locking

and unlocking system. Only the controls

change.

●

Switch the ignition off.

Close the driver's door.

What happens when locking the vehicle

with a second key

●

Touch (once) the locking sensor surface

Fig. 89

(arrow) on one of the front door

If there is a vehicle key inside the vehicle and

it is locked from the outside with a second ve-

hicle key, the key inside the vehicle is blocked

Unlocking the vehicle is confirmed with a

double flash of the indicator lights; locking by

a single flash.

›››

handles. The door that is used must be

closed.

for engine ignition page 216. In order to

enable engine ignition, press the  button on

the key inside the vehicle.

›››

If the vehicle is locked and then all doors and

the rear lid are closed leaving the last key

used inside the vehicle and none outside, the

vehicle will not lock immediately. All the ve-

hicle's indicator lights will flash four times.

The vehicle will lock after a few seconds if

you do not open any door or the rear lid.

In vehicles with the “Safe” security sys-

tem: closing and locking the doors

(Keyless-Exit)

Automatically disabling sensors

●

Switch the ignition off.

Close the driver's door.

If the vehicle is not locked or unlocked for a

long period of time, the proximity sensors on

the passenger doors are automatically disa-

bled.

Touch (once) the sensor surface Fig. 89

(arrow) on one of the front door handles.

›››

The vehicle will lock again after a few sec-

onds if you unlock the vehicle but fail to open

any door or boot hatch.

The vehicle locks with the “Safe” security sys-

If one of the sensor surfaces on the door han-

dles is often activated in an unusual manner

with the vehicle locked (e.g. by the branches

of a bush rubbing against it), all proximity

sensors are disabled for a certain period of

time.

tem page 105. The door that is used must

›››

be closed.

Unlocking and opening the doors

(Keyless-Entry)

●

Touch (twice) the sensor surface Fig. 89

(arrow) of one of the front door handles to

›››

lock the vehicle without activating the

“Safelock” security system page 105.

●

Grip one of the front door handles. When

›››

you do this, you touch the sensor surface

Sensors will again be enabled:

Fig. 89

(arrow) of the handle and the

›››

vehicle unlocks.

103

Operation

●

After a time.

The next time the door is locked/unlocked,

Keyless Access will be active again.

Note

OR: if the vehicle is unlocked with the but-

●

If the 12-volt vehicle battery has little or

ton  on the key.

no charge, or the vehicle key battery is al-

most or entirely out of charge, you will

probably not be able to lock or unlock the

vehicle with the Keyless Access system.

The vehicle can be unlocked or locked

Keyless Access permanent disconnection

function

●

OR: if the boot is opened.

OR: if the vehicle is unlocked manually with

You can deactivate the vehicle unlock with

Keyless Access permanently in the infotain-

ment system so that others cannot unlock or

start the vehicle.

the key.

manually page 108.

›››

Keyless Access temporary disconnection

function

●

To control the proper locking of the vehi-

cle, the release function is disabled for ap-

prox. 2 seconds.

You can deactivate the vehicle's Keyless

Access unlocking for one locking and unlock-

ing cycle.

Convenience functions

●

If the message Keyless access system

To close all the electric windows and the sun-

roof using the comfort function, keep a fin-

ger for a few seconds on the locking sensor

faulty is displayed on the screen of the

dash panel, abnormalities may occur in the

operation of the Keyless Access system.

Contact a specialised workshop. SEAT rec-

ommends visiting a SEAT dealership for

this.

●

Move the gear lever to position P (if the ve-

surface Fig. 89

(arrow) of the door han-

›››

hicle has automatic gearbox), since other-

wise the vehicle cannot be locked.

dle until the windows and roof have closed.

●

Close the door.

How the doors open when touching the sen-

sor surface on the door handle will depend

on the settings that have been activated in

the infotainment system, using the function

button  > Vehicle > Exterior > Central

locking.

●

Depending on the function set on the in-

Push the central locking button  on the re-

fotainment system for the mirrors, the exte-

rior mirrors will unfold and the surround

lighting will come on when unlocking the

vehicle using the sensor surface on the

driver and passenger door handles

mote control and touch the locking sensor

surface of the driver door handle

›››

Do not grasp the door handle; otherwise the

vehicle will not unlock. Deactivation is also

possible if the vehicle is locked through the

driver’s door lock.

Fig. 89

within the following 5 seconds.

page 129.

›››

CAUTION

●

If there is no valid key inside the vehicle

The sensor surfaces on the door handles

could engage if hit with a water jet or high

pressure steam if there is a valid vehicle

key in the proximity. If at least one of the

electric windows is open and the sensor

or the system fails to detect one, a warning

will display on the dash panel screen. This

could happen if any other radio frequency

signal interferes with the key signal (e.g.

from a mobile device accessory) or if the

key is covered by another object (e.g. an

aluminium case).

●

To check that the function has been deacti-

vated, wait at least 10 seconds, grip and pull

on the door handle. The door should not

open.

surface Fig. 89

(arrow) on one of the

›››

handles is activated continuously, all win-

dows will close.

The next time the door can only be unlocked

via the remote control or the lock cylinder.

104

Opening and closing

Lock the vehicle and activate the “Safe”

security system.

●

If the sensors are very dirty, e.g. have a

WARNING

layer of salt, the correct functioning of the

sensors on the door handles may be affec-

ted. In this case, clean the vehicle.

Do not leave anyone (especially children)

in the vehicle if it is locked from the outside

and the “Safe” security system is activa-

ted, as the doors and windows cannot then

be opened from the inside. Locked doors

could delay assistance in an emergency.

●

Press the locking button  once on the ve-

hicle key.

●

If the vehicle is fitted with an automatic

gearbox, it can only be locked by pressing

the parking lock button P.

Lock the vehicle without activating the

“Safe” system.

●

To improve the safety of your vehicle, the

●

Press the locking  button on the vehicle

key twice.

remote control of the system is equipped

with a position sensor. If this remote control

does not detect movement for a certain

length of time, the system will conclude

that the vehicle cannot be opened (e.g. on

a night table) so it will be disabled.

●

On vehicles with the Keyless Access locking

Anti-theft alarm system

and ignition system: touch the sensor surface

on the outside part of the door handle twice.

Description

When the “Safe” security system is disa-

bled, the following needs to be taken into

account:

●

If, when trying to block the vehicle, the

The anti-theft alarm makes it more difficult to

break into the vehicle or steal it. The system

will initiate acoustic and optical warning sig-

nals when your vehicle is tried to be forced.

last used key is still inside, all the turn sig-

nals will flash 4 times.

●

The vehicle can be unlocked and opened

from the inside using an door handle.

The anti-theft alarm is automatically turned

on when the vehicle is locked with the key.

The system is immediately activated and the

turn signal light located on the driver door will

flash along with the turn signals, indicating

that the alarm and the locking security sys-

tem (double lock) have been turned on.

Locking system “Safe”¹⁾

●

The anti-theft alarm is activated.

●

The vehicle interior monitoring system and

When the vehicle is blocked, the “Safe” se-

curity system puts the door handles out of

operation and prevents unauthorised persons

for entering. The doors cannot be opened

the anti-tow system are disabled.

“Safe” status

The flashing frequency of the diode in the

door sill immediately confirms the process.

Initially, the diode flashes in a fast sequence

for a brief period, then it stops for approxi-

mately 30 seconds and, lastly continues

flashing slowly.

from inside

›››

If any of the doors or the bonnet are open,

they will not be included in the protection

zones of the vehicle when the alarm is con-

nected. If the door or the bonnet are subse-

quently closed, they will be automatically

Depending on the vehicle, when switching the

ignition off, a warning may be displayed on

the control panel screen stating that the

“Safe” security system is activated.

Available depending on market and version.

105

Operation -> Anti-theft alarm system for Your Seat Leon 4 Door Fourth Generation (2021-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals