2021-2026 Seat Leon 4 Door Operation -> Interior lights User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Operation -> Interior lights for Your Seat Leon 4 Door Fourth Generation (2021-2026)

Lights  
In the vehicle settings menu of the infotain-  
ment system you can adjust the duration of  
the light switch-off delay, and activate and  
deactivate the function.  
Activating the “Leaving Home” function  
Fog lights with cornering light func-  
tion  
Unlock the vehicle using the remote control.  
The “Leaving Home” function is only activa-  
The cornering light function is an additional  
function to the dipped beam headlights to  
improve lighting of the side of the road when  
taking a sharp turn at low speed.  
ted when the lights are in  mode and the  
light sensor detects darkness.  
Activating the “Coming Home” function  
For vehicles with light and rain sensors.  
The “Leaving Home” lighting switches off  
in the following cases:  
The cornering light function works when the  
dipped beam headlights are already on and  
it is activated when driving at speeds below  
approximately 40 km/h (25 mph).  
Turn off the vehicle and turn off the ignition  
with the lights in  page 119 mode.  
›››  
Automatically, when the “Leaving Home”  
switch-on time ends (default 30 sec).  
The automatic “Coming Home” function is  
only active when the light sensor detects  
darkness.  
When the vehicle is locked using the remote  
control.  
If the steering wheel is turned or the turn  
signal is switched on, the front fog light grad-  
ually turns on. After the turn, the cornering  
light function is gradually switched off.  
If the light panel lamps are off page 119.  
›››  
For vehicles without light and rain sensors.  
With the ignition is switched on.  
Switch the ignition off.  
Activate the headlight flashers for approxi-  
When engaging reverse gear, both front fog  
Note  
mately 1 second.  
lights turn on.  
To activate the “Coming Home” and “Leav-  
ing Home” functions, the  lamp on the  
main switch of the lights should be on and  
the light sensor should detect darkness.  
When the driver door is opened, the “Coming  
Home” lighting comes on. The headlight turn-  
ing off time counts from when the last door or  
rear lid are closed.  
“Coming home” and “Leav-  
ing home” function  
The “Coming Home” lighting turns off in  
the following cases:  
The “Coming home” and “Leaving home”  
function lights up the vehicle’s immediate  
proximity when getting into and out of it in the  
dark. When switched on, the front position  
and dipped beam lights, tail lights and li-  
cense plate light come on.  
Automatically, once the headlight turning  
off time has elapsed.  
Automatically, when a vehicle door or the  
rear lid is still open 30 seconds after starting  
the engine.  
The “Leaving Home” is controlled by a photo-  
sensor.  
If the light panel lamps are off page 119.  
›››  
With the ignition is switched on.  
123  
Operation  
7. Always take the vehicle key with you when  
you leave the vehicle.  
Hazard warning lights  
Note  
The 12-volt vehicle battery will run down  
if the hazard warning lights are left on for a  
long time, even if the ignition is switched  
off.  
All turn signals flash simultaneously when the  
hazard warning lights are switched on. The  
two turn signal turn signal lamps   and the  
turn signal lamp in the switch will flash at  
the same time. The simultaneous hazard  
warning lights also work when the ignition is  
switched off.  
The use of the hazard warning lights de-  
scribed here is subject to the relevant stat-  
utory requirements.  
Emergency braking warning  
Dynamic headlight range control  
If the vehicle brakes suddenly and continu-  
ously at a speed of more than 80 km/h (50  
mph), the brake light flashes several times per  
second to warn the vehicles driving behind. If  
you continue braking, the hazard warning  
lights will come on automatically when the  
vehicle comes to a standstill. They switch off  
automatically when the vehicle starts to  
move again.  
3 Valid for vehicles fitted with a High lights  
Fig. 104 Dash panel: hazard warning lights  
switch  
The headlight range is automatically adjus-  
ted according to the vehicle load status when  
they are switched on.  
The hazard warning lights are used to draw  
the attention of other road users to your vehi-  
cle in emergencies.  
WARNING  
If your vehicle breaks down:  
Heavy objects in the vehicle may mean  
that the headlights dazzle and distract oth-  
er drivers. This could result in a serious ac-  
cident.  
1. Park your vehicle at a safe distance from  
moving traffic.  
WARNING  
2. Press the button to switch on the hazard  
The risk of an accident increases if your  
warning lights  
.
›››  
vehicle breaks down. Always use the haz-  
ard warning lights and a warning triangle to  
draw the attention of other road users to  
your stationary vehicle.  
3. Switch the ignition off.  
Driving abroad  
4. Apply the electronic parking brake.  
The light beam of the dipped beam lights is  
asymmetric: the side of the road on which  
you are driving is lit more intensely.  
5. Engage 1st gear in vehicles with a manual  
gearbox, or press the parking lock button  
P in vehicles with automatic transmission.  
Due to the high temperatures that the  
catalytic converter can reach, never park  
in an area where the catalytic converter  
could come into contact with highly inflam-  
mable materials, for example dry grass or  
spilt petrol. This could start a fire.  
When a car that is manufactured in a country  
that drives on the right travels to a country  
that drives on the left (or vice versa), it is  
6. Use the warning triangle to draw the at-  
tention of other road users to your vehicle.  
124  

Related Topics

Popular Owner Manuals