北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
However, the memory position can still
be retrieved by pressing the “
” button
on the access key fob. For information
about how to enable/disable the key-
less access function, refer to “Dis-
abling Keyless Access Function”
�P126.
. If a new position is registered for the
same access key fob, the previously
registered memory position data will
be deleted.
. If you are carrying 2 or more access
keys, seat position retrieval may not
be possible.
. If, while carrying an access key, 45
seconds passed after you enter the
operating range of the keyless access
function, it may not be possible to
retrieve the registered memory posi-
tion even if the door is open. For the
operating range of the keyless access
function, refer to “Locking and Un-
locking with “Keyless Access” Entry
Function” �P120.
Clearing the registered seat
position with access key fob
s01aa0307
1. Close the driver’s door.
2. Hold the access key fob and press and
hold the “SET” button, then press the
“
” button on the access key fob.
A chirp will sound, and the registered seat
position and outside mirror angle on the
passenger’s side will be cleared.
NOTE
After deleting the seat position, wait for a
few moments before registering a new
seat position.
HEAD RESTRAINT ADJUST-
MENT
s01aa04
WARNING
. Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck from
the rear. Also, never install the
head restraints backwards. Doing
so will prevent the head restraints
from functioning as intended.
Therefore, when the head re-
straints are removed, all head
restraints must be reinstalled
properly to protect vehicle occu-
pants.
. All occupants, including the driver,
should not operate a vehicle or sit
in a vehicle’s seat until the head
restraints are placed in their proper
positions in order to minimize the
risk of neck injury in the event of a
crash.
. The front seat head restraints are
designed to be installed into the
front seats only. The rear seat head
restraints are designed to be in-
stalled into the rear seats only. Do
not attempt to install the front seat
head restraints into the rear seats,
or the rear seat head restraints into
the front seats.
Both the driver’s seat and front passen-
ger’s seat are equipped with head re-
straints. Both head restraints are adjus-
table in the following ways.
– CONTINUED –
SEAT, SEATBELT AND SRS AIRBAGS
45
1
English 
