北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
. All occupants, including the driver,
should not operate a vehicle or sit
in a vehicle’s seat until the head
restraints are placed in their proper
positions in order to minimize the
risk of neck injury in the event of a
crash.
. The front seat head restraints are
designed to be installed into the
front seats only. The rear seat head
restraints are designed to be in-
stalled into the rear seats only. Do
not attempt to install the front seat
head restraints into the rear seats,
or the rear seat head restraints into
the front seats.
Rear windows side seating po-
sition
s01ac0301
S_103406-W
Head restraint
Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull
out the head restraint.
To install:
Install the head restraint into the holes
that are located on the top of the seatback
until the head restraint locks.
The head restraint should be adjusted so
that the center of the head restraint is
closest to the top of the seat occupant’s
ears. When the seats are not occupied,
lower the head restraints to improve
rearward visibility.
NOTE
When the head restraint cannot be pulled
out or installed due to insufficient clear-
ance between the head restraint and the
roof, tilt the seat and then perform the
installation and removal tasks.
Rear center seating position
s01ac0302
CAUTION
S_103214-MW
Incorrect (retracted position)
Correct (extended position)
The head restraint is not intended to
be used in the retracted position.
Before sitting on the seat, raise the
head restraint to the extended posi-
tion.
– CONTINUED –
SEAT, SEATBELT AND SRS AIRBAGS
51
1
English 
