03 Instruments and controls
High/low beam headlights
High beam flash
Active high beams (AHB)*
Pull the lever toward the steering wheel to
position 1. The high beams come on until the
lever is released.
When the engine is started, the low beams
are activated automatically if the headlight
AHB uses a camera at the upper edge of the
windshield to detect the headlights of oncom-
ing vehicles or the taillights of a vehicle
directly ahead. When this happens, the head-
lights will automatically switch from high
beams to low beams. When the camera no
longer detects the headlights/taillights of
other vehicles, your headlights will switch
back to high beams after several seconds.
control is in position
.
Related information
Active Bending Lights (ABL)* (p. 92)
•
Active high beams (AHB)* (p. 90)
•
Lighting panel (p. 89)
•
03
Tunnel detection (models with the rain
sensor* only) (p. 92)
•
To activate AHB:
•
Turn the headlight control to the
position.
The feature will begin functioning if the engine
has been running for at least 20 seconds and
the vehicle's speed is at least 12 mph
(20 km/h).
Headlight switch and steering wheel lever
High beam flash
Toggle between high and low beams
Continuous high beam headlights
With the headlight switch in the
(in dark
conditions only, when the daytime running
lights have automatically switched off and the
low beam headlights have switched on) or
position:
Pull the lever toward the steering wheel to
position 2 and release it to toggle
between low and high beams.
•
Headlight switch in the AUTO position
90
* Option/accessory, for more information, see Introduction.
English 
