2008-2016 Volvo Xc70 SUV Maintenance and service -> Electrical system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance and service -> Electrical system for Your Volvo Xc70 SUV Second Generation (2008-2016)

10 Maintenance and service  
Electrical system  
The electrical system is single-pole and uses  
the chassis and engine casing as a conductor.  
Fuses - general  
NOTE  
All electrical functions and components are  
protected by a number of fuses in order to  
protect the car's electrical system from dam-  
age by short circuiting or overloading.  
If the battery has become so discharged  
that everything is "black" and in principle  
the car does not have all the normal elec-  
trical functions and the engine is subse-  
quently started using an external battery or  
battery charger, then the Start/Stop func-  
tion will be activated. It will then be possi-  
ble for the engine to be auto-stopped but  
in the event of an auto-stop the Start/Stop  
function may fail to auto-start the engine  
due to inadequate capacity in the battery.  
The car has a voltage-regulated AC alterna-  
tor.  
10  
If an electrical component or function does  
not work, it may be because the component's  
fuse was temporarily overloaded and failed. If  
the same fuse fails repeatedly then there is a  
fault in the circuit. Volvo recommends that  
you visit an authorised Volvo workshop for  
checking.  
The size, type and performance of the starter  
battery depend on the car's equipment and  
function.  
IMPORTANT  
The battery must first be charged in order  
to ensure a successful auto-start after an  
auto-stop. At an outside temperature of  
+15 °C the battery needs to be charged for  
at least 1 hour. At a lower outside tem-  
perature a charging time of 3-4 hours is  
recommended. The recommendation is  
that the battery is charged using an exter-  
nal battery charger.  
If the starter battery is replaced, make sure  
you replace it with a battery with the same  
cold starting capacity and type as the orig-  
inal battery (see the label on the battery).  
Changing  
1. Look in the fuse diagram to locate the  
fuse.  
Related information  
Starter battery - replacement (p. 371)  
2. Pull out the fuse and check from the side  
to see whether the curved wire has  
blown.  
Starter battery - general (p. 369)  
If this is not possible then the recommen-  
dation is to temporarily deactivate the  
Start/Stop function until the battery has  
been adequately recharged.  
3. If this is the case, replace it with a new  
fuse of the same colour and amperage.  
WARNING  
For more information on charging the  
starter battery, see Starter battery - gen-  
eral (p. 369).  
Never use a foreign object or a fuse with  
an amperage higher than that specified  
when replacing a fuse. This could cause  
significant damage to the electrical system  
and possibly lead to fire.  
Related information  
Battery - symbols (p. 371)  
}}  
375  

Related Topics

Popular Owner Manuals