10 Maintenance and service
Lamp replacement - headlamps
NOTE
All of the headlamp bulbs are replaced via the
engine compartment. First loosen and remove
the whole headlamp.
Outside lighting such as headlamps and
rear lamps may temporarily have conden-
sation on the inside of the lens. This is nor-
mal, all exterior lighting is designed to
withstand this. Condensation is normally
vented out of the lamp housing when the
lamp has been switched on for a time.
10
Removing the headlamp
Set the car's electrical system in key position
0, see Key positions - functions at different
levels (p. 84).
Related information
Lamp replacement - headlamps (p. 361)
Detach the headlamp connector by
pressing down the clip with your thumb.
•
Lamp replacement - location of rear
lamps (p. 364)
•
At the same time, guide out the connec-
tor with your other hand.
Lamp replacement - vanity mirror lighting
(p. 365)
•
5. Lift out the headlamp and place it on a
soft surface to avoid scratching the lens.
Lamp replacement - lighting in cargo area
(p. 365)
•
6. Replace the bulb in question.
Lamp replacement - number plate lighting
(p. 364)
•
Securing the headlamp
1. Plug in the connector, a clicking sound
should be heard.
Pull out the headlamp's locking pins.
Pull the headlamp straight forward.
2. Reinstall the headlamp and locking pins.
Check that they are firmly inserted.
IMPORTANT
3. Check the lighting.
Do not pull the electrical cable, only the
connector.
The headlamp must be mounted and the con-
nector firmly connected before the lighting is
switched on or the remote control key is
inserted into the ignition switch.
}}
361
English 
