10 Maintenance and service
the level is too low because the oil has not
had time to flow down into the oil sump.
6. If required, check the level again, do it
after driving a short distance. Then repeat
steps 1 - 4.
Engine oil - checking and filling
The oil level is detected on certain engine
variants with the electronic oil level sensor, on
other engine variants it is checked with the oil
dipstick.
10
WARNING
Never fill above the MAX mark. The level
should never be above MAX or below MIN
as this could lead to engine damage.
Engine with oil dipstick6
WARNING
Do not spill oil onto the hot exhaust mani-
fold due to the risk of fire.
The oil level must be between the MIN and MAX
marks.
Engine with electronic oil level sensor,
4-cyl.
Measurement and filling if required
1. Ensure that the car is level. After switch-
ing off the engine it is important to wait
5 minutes to allow the oil time to run back
to the sump.
Dipstick and filler pipe.
Checking the oil level in a new car is espe-
cially important before the first scheduled oil
change.
2. Pull up and wipe the dipstick.
3. Re-insert the dipstick.
Volvo recommends checking the oil level
every 2 500 km. The most accurate measure-
ments are made on a cold engine before star-
ting. The measurement will be inaccurate if
taken immediately after the engine is
4. Pull it out and check the level.
5. If the level is close to MIN then 0.5 litres
should be added. If the level is signifi-
cantly below, then an additional amount
is required.
Filler pipe7.
switched off. The dipstick will indicate that
6
Does not apply to 4-cyl. engine or 5-cyl. diesel engine, which have electronic oil level sensor.
Engines with electronic oil level sensor do not have a dipstick.
7
354
English 
