10 Maintenance and service
1. Insert the remote control key in the igni-
tion switch11 and briefly press the
START/STOP ENGINE button to set the
car's electrical system to key position I.
For detailed information on key positions,
see Key positions - functions at different
levels (p. 84).
Fold up the wiper arm when it is in serv-
ice position. Press the button located on
the wiper blade mounting and pull
Replacing the wiper blades
straight out parallel with the wiper arm.
10
Slide in the new wiper blade until a "click"
is heard.
Check that the blade is firmly installed.
2. Briefly press the START/STOP ENGINE
button again to set the car’s electrical
system in key position 0.
4. Fold the wiper arm back towards the
windscreen.
3. Within 3 seconds, move the right stalk
switch up and hold it in position for
approx. 1 second.
The wipers return from service position to
their starting position when you briefly press
the START/STOP ENGINE button to set the
car’s electrical system to key position I (or
when the car is started).
> The wipers then move to standing
straight up.
The wipers return to their starting position
when you briefly press the START/STOP
ENGINE button to set the car’s electrical sys-
tem to key position I (or when the car is
started).
IMPORTANT
If the wiper arms in service position have
been folded up from the windscreen, they
must be folded back down onto the wind-
screen before the wipers are activated.
This is to avoid scraping the paint on the
bonnet.
11
Not required in cars with keyless start and lock system.
}}
367
English 
