Get Instrument cluster -> Dynamic Road Sign Display Guide for Volkswagen Caddy SUV Fifth Generation (2020-2025)

—When travelling at speeds of more than approximately 200 km/h(around 125 mph).

—Roads with bends.

—Road works.

—Poor roads.

—Adverse weather conditions.

—Sporty driving style.

—Driving with a trailer.

—The driver is distracted.

The Driver Alert System is reset in the following situations:

—The ignition is switched off.

—The driver seat belt is unfastened and the driver door is open.

—The vehicle has been stationary for longer than approximately 15 minutes.

The Driver Alert System is reset automatically if you drive slowly at a speed less than approx. 60 km/h(around

37 mph) for a long period. If the speed is increased, the system evaluates the driving behaviour again.

WARNING

The intelligent technology used in the Driver Alert System cannot overcome the laws of physics, and functions only

within the limits of the system. Do not let the extra convenience afforded by the Driver Alert System tempt you into

taking any risks when driving – this can cause accidents. During a long trip, plan regular and sufficient breaks.

● The driver is responsible at all times for their fitness to drive.

● Never drive a vehicle when you are tired.

● The system cannot always detect the driver's level of alertness. Observe the information in the section “Function

limitations”.

● In certain situations, the system may wrongly interpret intentional driving manoeuvres as a lack of alertness from

the driver.

● No urgent warning will be given in the event of the phenomenon known as “microsleep”.

● Observe the information in the instrument cluster display and respond according to the commands.

The Driver Alert System has been developed for use only while driving on motorways and good

roads.

If there is a system fault, proceed to a qualified workshop immediately to have the system

checked.

Dynamic Road Sign Display

Dynamic Road Sign Display uses a camera in the base of the interior mirror to monitor standard road signs and

informs the driver of any detected speed limits, overtaking restrictions and danger signs. Within the limits of the

system, the system also displays additional signs, e.g. temporary restrictions or restrictions in wet or foggy

conditions. In some cases, the system can also display the current speed limits on non-signposted routes.

The Dynamic Road Sign Display is always active when the ignition is switched on.

Displays

In addition to speed limits and overtaking restrictions, Dynamic Road Sign Display also detects the road sign which

indicates that all restrictions have been lifted on motorways and main roads in Germany. In all other countries in

which the system is operated, the current speed limit is displayed instead.

The road signs detected by the Dynamic Road Sign Display system are displayed on the instrument cluster depending

on the selected information profile. Road signs may also be displayed in the Infotainment system, depending on the

system installed in the vehicle.

No road signs available.

The system is in the initialisation phase.OR: the camera has not detected any regulatory or warning signs.

Fault: Dynamic Road Sign Display.

System fault. Go to a qualified workshop.

Speed warning currently not available.

Fault in the Dynamic Road Sign Display system speed warning. Go to a qualified workshop.

Dynamic Road Sign Display: Clean the windscreen!

The windscreen is dirty in the area of the camera or the camera view is impaired due to the weather conditions.

Clean the windscreen.

Dynamic Road Sign Display is currently restricted.

No data transmission from the Infotainment system. Check whether valid map data is loaded in the

Infotainment system. OR: the vehicle is located in an area that is not covered by the map stored in the

Infotainment system.

No data available.

Dynamic Road Sign Display is not supported in the country in which you are currently travelling.

Display of traffic signs

Fig. 1 On the display of the instrument cluster: Examples

of detected speed limits with accompanying additional

signs.

After validation and evaluation of the information from the camera, the Infotainment system and the current vehicle

data, the activated Dynamic Road Sign Display shows up to two valid road signs with the accompanying additional

signs, depending on the display location → Fig. 1:

1st 3rd position:

The road sign that currently applies is shown on the left-hand side of the display, e.g. a speed limit of130 km/h

(80 mph).

2nd 3rd position:

A further road sign may be displayed in second position, e.g. a danger sign, no overtaking sign or an alternative

speed limit.

Additional signs:

Any additional signs which are detected, such as those shown in wet conditions or in relation to time

restrictions, are displayed under the road sign that currently applies.

The display of danger signs is not available in all countries and the system may not be able to recognise all danger

signs.

Speed warning function

If the Dynamic Road Sign Display detects that an applicable speed limit has been exceeded, it can issue an acoustic

warning signal or display a message on the instrument cluster display.

You can set or completely deactivate the speed warning in the Assist systems menu in the Infotainment system

(→ Vehicle settings menu). The speed warning can be set to a value of 0 km/h(mph), 5 km/h (3 mph) or 10 km/h

(5 mph).

Trailer mode

In vehicles with a factory-fitted towing bracket and a trailer with an electrical connection to the vehicle, the display of

road signs that may apply to the vehicle when towing a trailer, e.g. applicable speed limits and no-overtaking signs,

can be activated or deactivated in the vehicle settings in the Infotainment system (→ Vehicle settings menu).

In trailer mode, the speed warning function display can be adjusted to the type of trailer or to legal requirements. The

settings can be adjusted in increments of 10 km/h (5 mph) within a range between 60 km/h (35 mph) and 130 km/h

(80 mph). If a higher speed is set than is permitted for driving with a trailer in the country in which you are currently

travelling, Dynamic Road Sign Display automatically issues a warning at the usual speed limit, e.g. at 80 km/h

(50 mph) in Germany.

No-entry warning

If the Dynamic Road Sign Display detects a no-entry sign on a one-way road or motorway entrance, it will issue an

acoustic warning signal or display a message on the instrument cluster display.

Function limitations

Dynamic Road Sign Display is subject to system-related limitations. The following conditions can restrict the function

of Dynamic Road Sign Display, or prevent it from working altogether:

—Poor visibility, e.g. due to snow, rain, fog or heavy spray.

—When dazzled, e.g. by oncoming traffic or sunlight.

—High speeds.

—Covered or dirty camera.

—Road signs that are located outside of the camera's field of view.

—Partially or fully hidden road signs, e.g. by trees, snow, dirt or other vehicles.

—Road signs that do not correspond to the standard design.

—Damaged or bent road signs.

—Variable road signs on gantries(changeable road sign display using LEDs or other light sources).

—Out-of-date map material of the Infotainment system.

—Vehicles have that have road sign stickers, e.g. speed restrictions on trucks.

WARNING

The intelligent road sign recognition system technology cannot overcome the laws of physics, and functions only

within the limits of the system. Do not let the extra convenience afforded by the Dynamic Road Sign Display system

tempt you into taking any risks when driving – this can cause accidents. The system is not a substitute for the full

concentration of the driver.

● Always adapt your speed and driving style to suit visibility, weather, road and traffic conditions.

● Poor visibility, darkness, snow, rain and fog can cause traffic signs to be not displayed or be incorrectly displayed

by the system.

● If the camera's field of view is dirty, covered or damaged, the function of the Dynamic Road Sign Display system

may be impaired.

WARNING

Driving recommendations and traffic symbols displayed by the Dynamic Road Sign Display system may differ from

the current traffic situation.

● Not all traffic signs can be recognised by the system and displayed correctly.

● Traffic signs and traffic regulations have priority over the recommendations and displays provided by the

Dynamic Road Sign Display system.

Some settings can be saved in the user accounts of the personalisation function and can therefore change

automatically when the user account is changed (→ Personalisation).

Time and date

Setting the time and date on the Infotainment system

1. Touch the Settings function button (→ Vehicle settings menu).

Time and

2. Select the date

menu option to set the time and date.

3. Select the time source:

—Automatic.

—Manual.

The time and date are displayed only on the Infotainment system.

Setting the time via the digital instrument cluster

1. Opening the Service menu (→ Service menu).

2. Select the Time menu.

3. Set the correct time with the arrow buttons or

Instrument cluster -> Dynamic Road Sign Display for Your Volkswagen Caddy SUV Fifth Generation (2020-2025)

Related Topics

Instrument cluster

Popular Owner Manuals

Latest Owner Manuals