1
4. Turn the bulb holder→ Fig. 2
in the direction of the arrow as far as it will go and pull it out to the rear.
5. Replace the defective bulb with a new bulb of the same type. If applicable, push the catch on the bulb holder
and pull the bulb straight out of the bulb holder.
1
6. Insert the bulb holder→ Fig. 2
it will go.
into the headlight and turn it in the opposite direction to the arrow as far as
1
7. Fit the rubber cover → Fig. 1
to the back of the headlight.
8. Close the bonnet (→ In the engine compartment).
Changing a bulb for dipped beam
The actions should only be carried out in the specified order:
1. Observe and follow the instructions in the checklist (→ Exterior lighting).
2. Open the bonnet (→ In the engine compartment).
2
3. Pull the rubber cover→ Fig. 1
4. Pull the bulb holder out→ Fig. 2
off the back of the headlight.
2
in the direction of the arrow.
5. Replace the defective bulb with a new bulb of the same type. If applicable, push the catch on the bulb holder
and pull the bulb straight out of the bulb holder.
2
6. Insert the bulb holder→ Fig. 2
7. Fit the rubber cover → Fig. 1
into the headlight and press in the opposite direction to the arrow.
to the back of the headlight.
2
8. Close the bonnet (→ In the engine compartment).
Changing a bulb for turn signal
The actions should only be carried out in the specified order:
1. Observe and follow the instructions in the checklist (→ Exterior lighting).
2. Open the bonnet (→ In the engine compartment).
3
3. Turn the bulb holder→ Fig. 2
in the direction of the arrow as far as it will go and pull it out to the rear.
4. Replace the defective bulb with a new bulb of the same type. If applicable, push the catch on the bulb holder
and pull the bulb straight out of the bulb holder.
3
5. Insert the bulb holder→ Fig. 2
it will go.
into the headlight and turn it in the opposite direction to the arrow as far as
6. Close the bonnet (→ In the engine compartment).
The illustrations show the right-hand headlight. The left-hand headlight is a mirror image of the one
shown.
There are various types of headlight, so the position and design of covers, bulbs and bulb holders may vary
from those shown in the illustrations.
It is not possible to change the LEDs of a daytime running light with LED technology. Go to a qualified
workshop.
451
English 
