Self-help -> Changing the side turn signal bulb for Your Volkswagen Caddy SUV Fifth Generation (2020-2025)

Fig. 3 In the left side panel: Remove the bulb holder.  
The actions should only be carried out in the specified order:  
1
1. Pull off the connector in the direction of the arrow→ Fig. 2  
1
.
2. Loosen three bolts with the screwdriver→ Fig. 3  
. If necessary, use a suitable interchangeable blade.  
3. Remove the bulb holder→ Fig. 3.  
4. Replace defective bulbs with a new bulb of the same type.  
Fitting the tail light cluster  
The actions should only be carried out in the specified order:  
1. Carefully insert the bulb holder→ Fig. 3 into the tail light cluster.  
1
2. Secure the bulb holder on the tail light cluster using the three screws→ Fig. 3  
.
3. Check that the bulb holder is positioned correctly and securely.  
1
4. Fit the connector on the bulb holder→ Fig. 2  
.
5. Insert the tail light cluster into the opening in the vehicle body and carefully push it into the holder→ Fig. 1.  
1
6. Tighten the securing bolts fully → Fig. 1  
.
7. Check that the tail light cluster is positioned correctly and securely.  
8. Close the boot lid or wing doors (→ Boot lid).  
Changing the side turn signal bulb  
454  
Fig. 1 On the side of the vehicle: removing the turn signal  
repeater.  
Fig. 2 Changing the bulbs in the turn signal repeater.  
The actions should only be carried out in the specified order:  
1. Observe and follow the instructions in the checklist (→ Exterior lighting).  
2. Push the turn signal repeater in direction of travel and swing it out at the rear→ Fig. 1.  
3. Lever the side turn signal out of the body.  
4. Turn the bulb holder in the direction of the arrow and pull the bulb rearwards out of the housing→ Fig. 2.  
5. Pull the bulb straight out of the bulb holder.  
6. Replace the defective bulb with a new bulb of the same type.  
7. Insert the bulb holder into the housing and turn it as far as it will go in the opposite direction to the arrow.  
8. Fit the spring clip of the turn signal repeater at front into the body, push it against the spring force in direction  
of travel, and engage it at the rear into the body.  
455