FOX 2004 ➤
3 - Cyl. injection engine - Edition 12.2009
– Tighten engine cylinder head bolts in the indicated tightening
sequence.
– Tighten screws to 30 Nm.
– Then, tighten the bolts at 90° with a hard spanner.
– Then, tighten 90° further.
Note
When turning the camshaft, the crankshaft cannot be in TDC.
Risk of damages to the valves/pistons.
– Adjust distribution times ⇒ page 28 .
– The remaining assembly steps are made by inverting the dis‐
assembly sequence, paying attention to the following:
– Fill cooling system ⇒ page 56 .
Check engine cylinder head for bending.
Max. permissible bending: 0.05 mm
1.3
Distribution times - check
Special tools and workshop equipment required
lk
♦ Fastening pins -T10120-
28
Rep. Gr.15 - Cylinder head, valve control mechanism
English 
