Advertisement

Advertisement

Ease of use and comfort -> Additional heating/ventilation system for Your Citroen Berlingo SUV Third Generation (2018-2025)

Ease of use and comfort  
Then press "Programmable heating/  
ventilation".  
► Select the "Status" tab to activate/deactivate  
the system.  
Rear heating and air  
conditioning  
3
► Select the "Other settings" tab to choose  
the "Heating" mode, to heat the engine and  
passenger compartment, or "Ventilation" to  
ventilate the passenger compartment.  
► Then set/save the time at which the  
preheating temperature will be reached for each  
selection.  
Heating  
This is an additional and separate system which  
heats the passenger compartment and improves  
defrosting performance.  
Press this button to save.  
This indicator lamp is lit while the system  
is programmed or set in operation  
remotely via the remote control.  
With CITROËN Connect Nav  
► Press the "Applications" menu.  
It flashes during the whole duration of the  
heating and goes off at the end of the heating  
cycle or when stopped using the remote control.  
If your vehicle is so equipped, the temperature of  
the air distributed by the system is the same as  
the selection for the front.  
► Press the "Vehicle Apps" tab.  
► Press "Temperature programming".  
► Press the "Status" tab to activate/deactivate  
the system.  
Ventilation  
Air flow  
This system allows ventilation of the passenger  
compartment with exterior air to improve the  
temperature experienced on entering the vehicle  
in summer.  
► Press the "Parameters" tab to select  
"Heating" mode to heat the engine and  
passenger compartment or "Ventilation" mode  
to ventilate the passenger compartment.  
► Then set/save the activation time for each  
selection.  
► Press one of the buttons 2 to increase/  
decrease the air flow.  
Additional heating/  
ventilation system  
Only available for Diesel vehicles.  
Programming  
► Press "OK" to confirm.  
With CITROËN Connect Radio  
You must allow at least 60 minutes  
between programming operations.  
Press Connect-App to display the main  
page.  
79  
Ease of use and comfort  
Depending on the outside temperature, a  
certain amount of pre-conditioning time is  
necessary in order to reach the programmed  
temperature by the stored activation time.  
This pre-conditioning time lasts up to 45 min.  
with a Diesel engine and up to 30 min. with a  
petrol engine.  
Off  
Diesel engine, and around 30 min. with a  
petrol engine.  
► Pressing and holding this button stops  
the heating immediately (confirmed by the  
red indicator lamp coming on briefly).  
The ventilation is activated provided that  
the battery is sufficiently charged.  
The heating is activated provided that:  
– the battery charge and the fuel level are  
sufficient,  
– the engine has been started since the  
previous heating cycle,  
– 60 minutes have elapsed between two  
heating requests.  
The indicator lamp in the remote control  
flashes for about 2 seconds if the vehicle  
has not received the signal, in which case  
you should move to a different location and  
repeat the command.  
Long range remote control  
(Depending on version.)  
This enables you to switch the heating in  
the passenger compartment on or off from a  
distance.  
The remote control has a range of about 0.6  
miles (1 km) in open country.  
Changing the battery  
The indicator lamp in the remote control will  
change to orange if the battery charge is low.  
If the indicator lamp is not on, the battery is  
discharged.  
Programmable heating is supplied by the  
vehicle fuel tank. Before use, make sure  
that you have sufficient fuel. If the fuel tank is  
on reserve, you are strongly recommended  
not to programme the heating.  
The additional heating must always be  
switched off while refuelling to avoid any risk  
of fire or explosion.  
To avoid the risk of poisoning or  
asphyxia, the programmable heating  
must not be used, even for short periods, in a  
closed environment such as a garage or  
► Use a coin to unscrew the cap and replace  
the battery.  
On  
► Pressing and holding this button starts  
the heating immediately (confirmed by the  
green indicator lamp coming on briefly).  
If the system is switched on using the  
long-range remote control, the maximum  
heating duration is around 45 min. with a  
80  
Ease of use and comfort  
workshop which is not equipped with an  
exhaust gas extraction system.  
Do not park the vehicle on a flammable  
surface (dry grass, dead leaves, paper, etc.)  
- Risk of fire!  
Programming  
Programming can be carried out from a  
smartphone using the MyCitroën App  
application.  
For more information on Remote functions,  
refer to the corresponding section.  
Operating conditions  
– The function is only activated when the  
ignition is switched off and the vehicle  
locked.  
– When the vehicle is not connected, the  
function is only activated if the battery charge  
level is greater than 50%.  
– When the vehicle is not connected and a  
recurring programme is active (e.g. from Monday  
to Friday), if two temperature pre-conditioning  
sequences are run without the vehicle being  
used, the programme will be deactivated.  
3
Glazed surfaces such as the rear screen  
or windscreen can become very hot in  
places.  
Never put objects on these surfaces; never  
touch these surfaces - Risk of burns!  
With CITROËN Connect Nav system  
In the Applications menu:  
Press "Car Apps" to display the applications  
home page.  
Select Temperature conditioning.  
Do not throw remote control batteries  
away, as they contain metals that are  
harmful to the environment. Take them to an  
approved disposal point.  
Courtesy lamp  
► Press + to add a programme.  
► Select the time of entry into the vehicle and  
the desired days. Press OK.  
► Press ON to activate this programme.  
The temperature pre-conditioning sequence  
begins approximately 45 minutes before the  
programmed time when the vehicle is connected  
(20 minutes when it is not connected) and is  
maintained for 10 minutes after.  
Automatic switching on/off  
The front courtesy lamp comes on when the key  
is removed from the ignition switch.  
All courtesy lamps come on when the vehicle is  
unlocked, when one of the corresponding doors  
is opened and when locating the vehicle using  
the remote control.  
They fade to off after the ignition is switched on  
and when the vehicle is locked.  
Temperature conditioning  
(Electric)  
This function allows you to programme the  
temperature in the passenger compartment to  
reach a pre-defined, non-modifiable temperature  
(approx. 21°C) before you enter the vehicle, on  
the days and at the times of your choice.  
This function is available when the vehicle is  
connected or not connected.  
You can set multiple programmes.  
Each one is saved in the system.  
To optimise the driving range, we recommend  
starting a programme while the vehicle is  
connected.  
Take care not to allow objects to come  
into contact with the courtesy lamp.  
The fan noise that occurs during  
temperature pre-conditioning is perfectly  
normal.  
81