Get Ease of use and comfort -> Front seats Guide for Citroen Berlingo SUV Third Generation (2018-2025)

Ease of use and comfort

– In row 3, be careful not to leave your feet

under the row 2 seat while it is being tilted.

– When a row 3 seat is in the fully folded

position, ensure that the strap is correctly

hooked to the Top Tether ﬁxing of the row 2

backrest: risk of unexpected tipping of the

seat.

General

recommendations for the

seats

Front seats

Correct driving position

Before taking to the road and to make the most

of the ergonomic layout of the instruments and

controls, carry out these adjustments in the

following order:

For safety reasons, seat adjustments

must only be made when the vehicle is

stationary.

– head restraint height.

– seat backrest angle.

– seat cushion height.

– longitudinal seat position.

– steering wheel height and reach.

– rear view mirror and door mirrors.

Before carrying out the manoeuvres,

check that nothing and no one is

obstructing the moving elements and their

locking.

To avoid sudden folding, take care to hold the

backrest and support it until it is horizontal.

Never put your hand underneath the seat

cushion to guide the seat downwards or

upwards, you could get your ﬁngers trapped.

Place your hand on the grip/strap (depending

on equipment) at the top of the seat cushion.

Folding or unfolding the seat backrests

must only be done with the vehicle

stationary.

Before moving the seat backwards,

ensure that there is no person or object

that might prevent the full travel of the seat.

There is a risk of trapping or pinching

passengers if present in the rear seats or of

jamming the seat if large objects are placed

on the ﬂoor behind the seat.

Please note: an incorrectly latched

backrest compromises the safety of

passengers in the event of sudden braking or

an impact.

The contents of the boot may be thrown

forward - risk of severe injury!

Do not place hard or heavy objects on

the backrests forming a table. They could

become dangerous projectiles in the event of

sudden braking or a collision.

– Do not remove a head restraint without

stowing it; secure it to a support inside the

vehicle.

Once these adjustments have been

made, check that the instrument panel

can be viewed correctly from your driving

position.

– Check that the seat belts remain accessible

to the passenger and easy to fasten.

– Passengers must never take their seat

without adjusting and fastening their seat belt.

Ease of use and comfort

Adjustments

Longitudinal

Tilting the backrest

► Push the control backwards then use your

weight and your legs to adjust the backrest.

Lumbar

(driver only)

► To put the armrest in the vertical position,

raise it until it locks into place.

► Lower the armrest to return it to the position

for use.

The armrest can be removed from the passenger

seat.

► Raise the control and slide the seat forwards

or backwards.

Removing the armrest

► Raise the armrest into the vertical position.

Height

► Turn the knob to obtain the desired level of

lumbar support.

(driver only)

Armrest

► Push the armrest shaft towards the backrest.

► While holding it in this position, rotate the

armrest towards the rear.

► Pull the armrest to detach it from the

backrest.

► If ﬁtted to the vehicle, pull the control

upwards to raise or push it downwards to lower,

as many times as necessary to obtain the

position required.

Reﬁtting the armrest

For more information on the Seat belts,

refer to the corresponding section.

Ease of use and comfort

Retractable position

► Approximately 30 seconds after starting the

engine, press the control.

It can be activated when the outside temperature

is below 20°C.

The temperature is controlled automatically.

Pressing again interrupts operation.

► Slot the armrest into the backrest, ensuring

that you align the bayonet lugs with the holes.

► Push the armrest shaft towards the backrest.

► While holding it in this position, rotate the

armrest towards the front. The armrest is once

again secured onto the backrest.

► If the centre console inconveniences you,

remove the passenger's seat armrest.

► Push the control rearwards fully to tilt and

guide the assembly.

This position allows you to transport long loads

inside the vehicle with the doors closed.

When retracted, the maximum permitted weight

on the backrest is 50 kg.

If you press the control while the engine

is not running, the request will be

memorised for approximately 2 minutes.

Storage compartment under

the seat

► To reposition the seat cushion, raise the

backrest until it locks in the raised position.

With the two-seat front bench seat, the driver's

seat control switches the heating on or oﬀ for the

bench seat’s outer seat.

Heated seat control

Do not use the function when the seat

is not occupied.

Reduce the heating intensity as soon as

possible.

When the seat and passenger compartment

have reached a satisfactory temperature,

► Lift the passenger’s seat cushion to access

the storage compartment.

Ease of use and comfort

switch the function oﬀ; reducing electrical

consumption in turn decreases energy

consumption.

Steering wheel

adjustment

Mirrors

Door mirrors

Prolonged use of heated seats is not

recommended for people with sensitive

skin.

Adjustment

There is a risk of burns for people whose

perception of heat is impaired (e.g. illness,

taking medication).

To keep the heated pad intact and to prevent

a short circuit:

– Do not place heavy or sharp objects on the

seat.

– Do not kneel or stand on the seat.

– Do not spill liquids onto the seat.

– Never use the heating function if the seat

is damp.

► When stationary, pull the control lever to

release the steering wheel.

► Adjust the height and reach.

► Lower the control lever to lock the steering

wheel.

► Move control A or turn control C (depending

on the version you have) to the right or to the left

to select the corresponding mirror.

As a safety precaution, these operations

must only be carried out while the vehicle

is stationary.

► Move control B or C (depending on the

version you have) in any of the four directions to

adjust.

► Return control A or C (depending on the

version you have) to its centre position.

As a safety measure, the mirrors should

be adjusted to reduce the blind spots.

The objects observed are, in reality, closer

than they appear.

Take this into account when assessing the

distance of vehicles approaching from behind.

Ease of use and comfort -> Front seats for Your Citroen Berlingo SUV Third Generation (2018-2025)

Related Topics

Ease of use and comfort

Popular Owner Manuals

Latest Owner Manuals