Steering mounted controls
Exceeding the programmed speed
Switching the system off
Operating fault
Pressing the accelerator pedal in order to
exceed the programmed speed will have
no effect unless you press the pedal firmly
beyond the point of resistance.
-
Place the ring in the central O position
or switch off the ignition to switch the
system off.
The programmed speed is cleared then
replaced by dashes.
Contact a CITROËN dealer or a qualified
workshop to have the system checked.
The last programmed speed remains in the
memory.
If the limiter is unable to prevent an increase
in the speed of the vehicle because of the
profile of the road or when going down a
step hill, the programmed speed may be
exceeded.
Good practice
The limiter is deactivated temporarily and
the programmed speed flashes.
In any event, the speed limiter cannot
replace the need to observe speed limits,
nor can it replace the need for vigilance on
the part of the driver.
To return to the limiter function, reduce your
speed to below the programmed speed.
Always pay attention to the profile of the
road and sharp acceleration and stay in
complete control of your vehicle.
To avoid any jamming under the pedals:
-
ensure that the mat and its fixings on the
floor are positioned correctly,
-
never place one mat on top of another.
English 
