Ventilation
The temperature near the heater must not
exceed 120 °C. A temperature higher than
this (for example in the case of painting in
an oven) could damage the components of
the electronic circuits.
Setting the operating period
Switching off the heating
The period of operation can be set to
between 10 and 60 minutes.
In the case of deferred operation, the
heating stops at the end of the programmed
period.
Press and hold the "set" button.
In the case of immediate
operation, press this button again
to switch off manually.
The additional heating is fitted with
a temperature limiter which cuts off
the combustion in the event of engine
overheating due to a lack of coolant. Check
the level and if necessary top-up following
the advice given in the "Checks - Levels"
section. Then press the programme
selection button before switching the heating
on again.
The heating cycle indicator and
the screen go off.
At the same time press the "<" or
">" button.
The time and the time setting
indicator come on.
Good practice
Press and hold the "set" button again.
At the same time press the "<" or ">" button
To avoid any risk of poisoning or
again.
asphyxiation, the additional heating must
not be used, even for short periods, in
an enclosed space such as a garage or
workshop which is not fitted with an exhaust
gas extraction system.
The programmed operating period is
displayed and the heating or ventilation
cycle indicator flashes.
Have the additional heating checked at
least once a year at the beginning of
winter. Maintenance and repairs should only
be carried out by a CITROËN dealer or a
qualified workshop.
Adjust the period by pressing the "<" or ">"
The additional heating switches off when the
battery voltage is low, so as to allow engine
starting.
button.
The setting is confirmed by the period
disappearing from the screen or by pressing
the "set" button again
Use only genuine replacement parts.
The additional heating is supplied by the
vehicle's fuel tank. Ensure that the low fuel
warning lamp is not on.
Always switch off the additional heating
when filling with fuel to avoid any risk of fire
or explosion.