Steering mounted controls
LEd dAYtIME runnInG LAMPS
On starting the vehicle, in daylight the LED
daytime running lamps come on automatically.
AutOMAtIc ILLuMInAtIOn
GuIdE-ME-HOME LIGHtInG
If your vehicle is fitted with this function, the
dipped beam headlamps are switched on
automatically if the light is poor.
If your vehicle is fitted with this function:
when you leave your vehicle, the dipped
beam headlamps remain on for the selected
duration (when leaving a car park for
example).
If the sidelamps and headlamps are switched
on manually or automatically, the daytime
running lamps go off.
In fog or snow, the sunshine sensor may
detect sufficient light. Therefore, the lamps
will not be switched on automatically. If
necessary, you must switch on the dipped
beam headlamps manually.
Programming
For countries where exterior lighting by
day is not a legal requirement, you can
activate or deactivate the function via the
configuration menu.
Ignition off or key in the StOP position.
They are switched off when the light returns
to a sufficient level.
Within 2 minutes after switching off the
engine, position the ignition key in the STOP
position or remove it.
Pull the lighting stalk towards the steering
wheel.
Do not cover the sunshine sensor at
the top centre of the windscreen.
You can adjust the sensitivity of the
sunshine sensor.
the indicator lamp comes on in
the instrument panel.
Refer to the "Technology on board -
Vehicle configuration" section.
Each action on the lighting stalk,
pulled towards the steering
wheel, prolongs the guide me home
lighting by 30 seconds up to approximately
3 minutes. When this time has elapsed, the
lamps are switched off automatically.
Activation
Turn the ring to this position.
Deactivate this control by keeping the stalk
pulled towards the steering wheel for more
than 2 seconds.
The lamps are switched off automatically
when the ignition is switched off.
3
English 
