Advertisement

Advertisement

Ease of use and comfort -> Wiper control stalk for Your Citroen Relay Van 2014-2024

Steering mounted controls  
Activation  
If the situation requires a change of  
headlamp beam, the driver can take over at  
any time.  
The system may suffer interference or  
not work correctly:  
F
Turn the lighting control stalk  
ring to this position.  
-
-
-
Under conditions of poor visibility  
(falling snow, heavy rain or dense  
fog, ...),  
F
Flashing the headlamps again pauses  
the function and the system changes to  
"automatic illumination of headlamps"  
mode.  
F
F
Activate the function with the MOdE  
button; in the "Automatic headlamp  
dipping" menu, select "ON".  
If the windscreen is dirty, misted or  
obscured (by a sticker, ...) in front  
of the camera,  
The function is deactivated automatically  
below 9 mph (15 km/h).  
Refer to the "Technology on board -  
Vehicle configuration" section.  
If the vehicle is facing highly  
reflective signs.  
If main beam is still needed, flash the  
headlamps again; main beam will then  
remain on until the vehicle reaches a speed  
of 25 mph (40 km/h).  
Flash the headlamps (going beyond  
the point of resistance) to activate the  
function.  
The system is not able to detect:  
-
Road users that do not have their  
Above 25 mph (40 km/h), the function is  
reactivated automatically (provided that the  
headlamps have not been flashed again in  
the meantime, to change to dipped beam).  
Operation  
own lighting, such as pedestrians,  
Once the function is activated, the system  
operates as follows:  
-
Vehicles whose lighting is  
obscured, such as when running  
behind a safety barrier on a  
motorway, for example,  
If the ambient light level is sufficient and/or if  
the traffic conditions do not allow illumination  
of the main beam headlamps:  
-
Vehicles at the top or bottom of a  
steep slope, on winding roads, on  
crossroads.  
-
Dipped beam is maintained,  
this indicator lamp comes on  
in the instrument panel.  
deactivation  
F
Turn the lighting control stalk ring to the  
"dipped beam" position.  
If the ambient light level is very low and the  
traffic conditions permit:  
-
Main beam comes on  
automatically: these  
indicator lamps come  
on in the instrument  
panel.  
3