2024-2026 Cupra Terramar SUV Assistant systems -> Lane Assist system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Assistant systems -> Lane Assist system for Your Cupra Terramar SUV First Generation (2024-2026)

Assistant systems
213
Emergency brake assistance system (Front Assist)
●
Front Assist may decelerate the vehicle un-
til it stops completely. However, the brake
system does not halt the vehicle perma-
nently. Use the foot brake!
Pedestrian and cyclist recognition
The system recognises pedestrians and cyclists
who travel in the same lane and direction and
pedestrians and cyclists who transversely cross
the vehicle's path.
Pedestrian and cyclist recognition technology
cannot exceed the physically prescribed limits
and works exclusively within the system’s limits.
The responsibility for braking always depends
on the driver.
The pedestrian and cyclist recognition can
cause undesired warnings and braking inter-
ventions, e.g. with a hidden radar sensor or a
dirty camera eld of vision.
Be ready to take charge of the vehicle at any
time.
The pedestrian and cyclist recognition operat-
ing speed range is lower than that of Front As-
sist.
Dodge assist
Dodge assist helps the driver avoid an obstacle
in critical conditions.
Once the Front Assist has activated a critical
warning, if the driver intends to dodge the ob-
ject, the swerve assist will help correct the tra-
jectory. The driver must start and nish the
manoeuvre, as this is an assistance system and
not an autonomous one.
The system is active between approximately
30km/h (20mph) and 150km/h (90mph).
Limitations
This system does not react to objects crossing
the path of the vehicle or to animals. The basic
limitations of Front Assist must also be taken
into account›››
page214.
Turn-o assist
Turn-o assist can avoid a collision with a vehi-
cle approaching in the opposite direction, by
braking the vehicle itself when the intention is
to turn.
This system is active up to 20km/h (12mph).
Limitations
The turn-o assist function is available if you
have indicated your intention to turn by acti-
vating the turn signal, you have turned the
steering wheel and the turning path has star-
ted.
It only reacts to vehicles that are in the path of
the vehicle (not to animals, people, etc.).
The basic limitations of Front Assist must also
be taken into account›››
page214.
Junction assist
Junction Assist can prevent the vehicle from
colliding with a vehicle crossing the road as it
enters an intersection or junction.
If there is a risk of collision when exiting an
exit or entering a junction, Junction Assist can
issue a visual and audible warning and brake
the vehicle. This can reduce the risk of an acci-
dent.
Displays
At low speeds, the park assist display uses
coloured segments to show detected crossing
traic.
Fig.140 In the infotainment system:
junction assist display.
214
Assistant systems
Yellow segment: Junction assistant has
detected crossing traic. Pay attention
and be prepared to brake.
Red segment: Junction assist has detec-
ted a potential collision with crossing traf-
c. Brake!
Depending on the situation, the coloured ar-
rows are also shown on the head-up display or
on the instrument cluster. These indicate the
direction from which cross traic is approach-
ing.
Speed range
Junction assist is available in a speed range
from 0km/h (0mph) to around 65km/h (close
to 40mph).
Limitations
Junction assist does not react to road users
who are hidden by structures or other road
users. Road users leaving a place where they
were concealed may be detected with a delay.
Always keep in mind the basic limitations of the
Front Assist ›››page214 system.
System limitations
Front Assist has certain limitations inherent to
the system. Thus, in certain circumstances,
some of the reactions may be inappropriate
from the driver's standpoint. So pay attention
in order to intervene if necessary.
The following conditions may cause Front
Assist not to react or to do so too late:
The indication will be shown on the in-
strument cluster display in the rst few
instants of driving after switching on the
ignition, due to the system’s initial auto-
calibration.
Unrecognised objects
●
Vehicles travelling outside the reach of the
sensors at close range from your own vehicle.
●
Vehicles that suddenly change to the lane on
which your vehicle is travelling.
●
Pedestrians that cannot be recognised be-
cause they are partially or totally hidden.
●
Objects such as walls, posts, fences, trees or
garage doors.
●
Loads and accessories of other vehicles that
protrude over the sides, backwards or over the
top.
●
In the case of pedestrians or cyclists standing
or approaching in the opposite direction.
Operating limitations
In the following situations, Front Assist may not
work, or may work in a limited or unwanted
way:
●
If Front Assist or the front camera are disa-
bled or broken.
●
If the radar sensor or the front camera are
dirty or covered.
●
On taking tight bends or complex paths.
●
When pressing the accelerator rmly or at
full throttle.
●
If the ESC is adjusting or is broken.
●
If several brake lights of the vehicle or electri-
cally connected trailer are damaged.
●
If the vehicle is reversing.
●
In case of snow or heavy rain.
●
In case of dazzling sun or total darkness.
●
Entrances and exits of tunnels.
●
In complex driving situations (such as traic
islands, cut-through roundabouts, etc.), Front
Assist may issue warnings and unnecessarily in-
tervene in braking.
For more details, see section ›››page194,
System limits.
Manual activation and deactivation
of the function
Front Assist indicators appear on the instru-
ment cluster display.
Front Assist is active whenever the ignition is
switched on. When the vehicle is started, Front
Assist may not be available for a short period of
Assistant systems
215
Lane Assist system
time while the system starts. During this phase,
the instrument cluster screen will display the
following indication .
When Front Assist is deactivated, so too are
the advance warning and the distance warning
functions.
CUPRA recommends leaving Front Assist ac-
tivated except in the situations explained in
section page215, Temporarily deactivating
Front Assist.
Activating and deactivating Front Assist
With the ignition switched on, Front Assist can
be deactivated or activated as follows:
●
In the infotainment system: press the func-
tion button > Driver assist > Smart Assis-
tants > Front Assist ›››page39.
●
OR: Select the corresponding menu option
using the button for the assistants systems
›››page194.
This indication will be displayed in the in-
strument cluster when Front Assist is de-
activated.
Each time the ignition is switched on, Front
Assist will reappear as active.
Switching distance warning on and o
The safety distance warning can be activated
or deactivated in the infotainment system us-
ing the function button
> Driver assist >
Smart Assistants > Front Assist ›››page39.
Each time the ignition is switched on, the dis-
tance warning will reappear as active.
CUPRA recommends having the safety dis-
tance warning activated, with the exceptions
described in section
page215, Temporarily
deactivating Front Assist.
Activating or deactivating the swerve and
turn and junction assist
The swerve and turn assistance systems can
be activated or deactivated in the infotain-
ment system using the function button >
Driver assist > Smart Assistants > Front Assist
›››page39.
Whenever the ignition is switched on, the
swerve and turn and junction assist will reap-
pear as active.
CUPRA recommends having the swerve and
turn assistance systems activated except in
the exceptions described in section page215,
Temporarily deactivating Front Assist .
Temporarily deactivating Front Assist
In the following situations Front Assist should
be deactivated due to the system's limitations:
●
When the vehicle is to be towed.
●
If the vehicle is on a test bed.
●
If the radar sensor or the front camera is
faulty.
●
If the radar sensor or the front camera has
suered a violent blow.
●
If it intervenes several times unnecessarily.
●
If the radar sensor or the front camera is
temporarily covered by an accessory.
●
When the vehicle is going to be loaded onto
transportation.
●
If the windscreen is damaged in an area that
covers the vision of the front camera.
Lane Assist system
Introduction
The Lane Assist System helps the driver stay
in his/her lane within the physical limits of the
system. This function is not suitable and is not
designed to keep the vehicle automatically in
the lane.
Using the camera located in the windscreen,
the Lane Assist system detects the lane boun-
daries dividing the lanes in which the vehi-
cle is travelling. If the vehicle gets too close
to the detected lane limits, the system alerts
the driver through a corrective motion of the
steering wheel. The driver can cancel the
steering corrective action at any time.
No warning will be given when the turn signals
are activated, given that the Lane Assist system
understands that a lane change is required.
System limits
Use the Lane Assist system only on large, well-
maintained motorways and highways.
216
Assistant systems
1
2
The system is not available under the following
conditions:
●
The speed limit allowed is below approx. 60
km/h (35 mph).
●
The system has not detected any lane lines.
●
On tight bends.
●
Temporarily in very sporty driving situations.
●
If the driver rmly recties a system interven-
tion.
●
If a lane marking is crossed despite system
intervention.
●
If the driver does not react to a request to
intervene.
WARNING
The intelligent technology in the Lane Assist
system cannot change the limits imposed by
the laws of physics and by the very nature of
the system. Careless or uncontrolled use of
the Lane Assist system may cause accidents
and injury. The system is not a replacement
for driver awareness or manoeuvres when
driving.
●
Always adapt your speed and the distance
to the vehicles ahead in line with visibility,
weather conditions, the condition of the
road and the traic situation.
●
Always keep your hands on the steering
wheel so it can be turned at any time. The
responsibility of staying in the lane is always
the driver's.
●
The Lane Assist system does not detect
all road markings. The road surfaces, road
structures or objects in poor condition can
be incorrectly detected as road markings un-
der certain circumstances by the Lane Assist
system. Immediately counter any unwanted
intervention of the system.
●
Please observe the indications on the in-
strument cluster and act as is necessary if the
traic situation permits.
●
In the following situations there may be un-
desired interventions of the system or it may
not intervene at all. In these situations, spe-
cial attention is required from the driver and,
where appropriate, the temporary deactiva-
tion of the lane assist warning system:
–
In very sporty driving situations.
–
In adverse weather conditions and roads
in poor condition.
–
When passing through road works.
–
Before gradient changes of grade and
river beds.
●
Always observe the vehicle surroundings
carefully and drive proactively.
●
When the area of vision of the camera be-
comes dirty, covered or is damaged, the Lane
Assist system function can be aected.
Driving with the Lane Assist System
Fig.141 On the instrument cluster display:
indications of the lane assist system.
Yellow line: The system intervenes assisting
on the represented side.
White line: Lane line detected. The system
is ready to intervene on the displayed side.
When the line is grey, the lane line is de-
tected but the system is in a passive state
or not available for intervention.
Depending on the equipment, additional de-
tails of the lane marking line currently detec-
ted by the camera, e.g. dashed road markings,
can also be displayed on the instrument cluster
display.
Depending on the equipment, there is
also an indication on the Head-up-Display
›››
page22.
Assistant systems
217
Lane Assist system
Control lamps
Lights up grey
Lane departure warning system
switched to passive and not available for
guidance.
Lights up green
Lane Assist system active and available.
Lights up yellow
The Lane Assist system is intervening by
adjusting the steering.
Switching the lane assist system on or o
In some countries, the Lane Assist system is
always activated when the ignition is switched
on. It is switched on and o and displayed in
the infotainment system’s Vehicle menu
and also in the driving assistants menu dis-
played on the instrument cluster, by pressing
the button on the multifunction steering
wheel.
The Lane Assist system is designed to actively
intervene as of approximately 65 km/h (40
mph) and if it has detected the lane bounda-
ries (system status: active).
When a turn signal is activated, the system
temporarily switches to a passive state in the
indicated direction and is available for opera-
tion in the opposite direction.
An energetic rotation or rectication of the
steering wheel by the driver causes the system
to temporarily switch to a passive state.
When Lane Assist is switched o, the yel-
low disconnection warning lamp lights up
in the instrument cluster (depending on
the country).
Note
If a system fault persists, Lane Assist may
switch o automatically.
Driver intervention prompt
If the steering is not corrected manually, the
system prompts the driver an indication on the
instrument cluster display and audible warn-
ings.
If no reaction is obtained from the driver, the
system switches to a passive state.
Depending on the equipment, Emergency As-
sist is activated.
Regardless of the steering manoeuvres, an in-
dication on the instrument cluster display and
audible warnings also prompt the driver to
drive in the middle of the lane if the steering
correction lasts longer than reasonable.
Steering wheel vibration
The following situations may result in a steering
wheel vibration:
●
The lane ceases to be recognised during a
sudden intervention in the steering by the sys-
tem.
It is also possible to select steering wheel vibra-
tion in the Vehicle menu of the infotainment
system. In this case, when a vehicle with Lane
Assist switched on crosses over a detected lane
marking, the steering wheel will vibrate.
Troubleshooting
The lane departure warning assistant
is not available
The control lamp lights up in yellow. A relevant
warning is also displayed on the instrument
cluster display.
●
There is a fault or a defect. Switch the engine
o and on again.
●
The eld of vision of the camera is dirty.
Clean the windscreen ›››page394.
●
The camera has decreased visibility due to
accessories or adhesives.
If the camera’s eld of view is aected by dirt,
snow, accessories, stickers or other obstruc-
tions, the following temporary message may
appear on the instrument cluster, accompa-
nied by an audible warning:
“ Driver assist limited now. Front sensors
without visibility.”
See more information on this topic in the
section “Drive assist sensors and cameras”
›››
page195.

Related Topics

Popular Owner Manuals