2024-2026 Cupra Terramar SUV Assistant systems -> Lane departure warning (Side Assist) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Assistant systems -> Lane departure warning (Side Assist) for Your Cupra Terramar SUV First Generation (2024-2026)

222
Assistant systems
WARNING
If Emergency Assist intervenes inoppor-
tunely, serious accidents and injuries may
occur.
●
If the vehicle behaves dierently than ex-
pected, interrupt the intervention of the
Emergency Assist by over-accelerating, brak-
ing or moving the steering wheel.
●
Do not use Travel Assist or Lane Assist.
Have the system checked by a specialised
workshop.
Troubleshooting
Emergency Assist not available
The control lamp lights up in yellow. A relevant
warning is also displayed on the instrument
cluster display.
●
There is a fault or a defect. Turn the drive
system o and on again.
●
If the problem persists, switch o the Emer-
gency Assist and go to a specialised workshop.
Lane departure warning
(Side Assist)
Introduction
The lane departure warning uses radar sen-
sors to monitor the areas behind the vehicle
›››
page6. The system does this by measuring
the vehicle's distance from other vehicles and
its speed dierential. The lane departure warn-
ing will not work at speeds of less than approx.
15km/h (9mph).
Lane width is not detected individually, but is
rather pre-congured in the system. Thus if
you are driving in wide lanes or in between
two lanes, the indications may be incorrect.
Furthermore, the system can detect vehicles
driving in the lane next to you (if there are any),
and can also detect stationary objects such as
dividers, and thus give an incorrect indication.
Trailer mode
Side assist is automatically deactivated and
cannot be switched on if the factory-tted
tow-bar is electrically connected to a trailer or
similar device.
As soon as the driver starts to drive with a
trailer connected electrically to the vehicle, a
message is displayed on the instrument cluster
display indicating that side assist is switched
o. Once the vehicle trailer has been disen-
gaged, side assist will return to the initial state
prior to the moment the trailer was electrically
connected.
If the tow-bar is not factory tted, side assist
should be switched o manually when driving
with a trailer.
Physical limitations inherent to the system
In some situations the lane departure warning
may not interpret the traic situation correctly.
I.e. in the following situations:
●
on tight bends;
●
in the case of lanes with dierent widths;
●
in areas with signicant gradient changes;
●
in adverse weather conditions;
●
in the case of special constructions to the
side of the vehicle, e.g., high or irregular divid-
ers.
WARNING
The smart technology incorporated into Side
Assist cannot overcome the limits imposed
by the laws of physics; it only works within the
limits of the system. Accidents and severe
injury may occur if Side Assist is used negli-
gently or involuntarily. The system is not a
replacement for driver awareness.
●
Adapt your speed and safe distance to the
vehicle in front of you at all times to suit visi-
bility, weather, road and traic conditions.
Assistant systems
223
Lane departure warning (Side Assist)
●
Keep your hands on the wheel at all times
to be ready to intervene in the steering at any
time.
●
Pay attention to the control lamps that may
come on in the external interior mirrors and
on the instrument cluster, and follow any in-
structions they may give.
●
The lane departure warning could react to
any special constructions that might be pres-
ent to the sides of the vehicle, e.g. high or
irregular dividers. This may cause erroneous
warnings.
●
Never use the lane departure warning on
unpaved roads. The lane departure warning
has been designed for use on paved roads.
●
Always pay attention to the vehicle's sur-
roundings.
●
The control lamps of the lane departure
warning may have limited functionality due
to solar radiation.
Note
If Side Assist does not work as described in
this chapter, stop using it and contact a spe-
cialised workshop.
Driving with Side Assist
Fig.144 Control lamp of the lane departure
warning.
Fig.145 Control lamp of the lane departure
warning.
Connecting and disconnecting
Side Assist can be switched on and o by ac-
cessing the Assistants menu in the infotain-
ment system.
Additionally it can be switched on and o by
accessing the Assistants menu on the instru-
ment cluster.
When the lane departure warning is ready to
operate, the indications in the control lamps
will turn on briey as conrmation.
When the vehicle is restarted, the last adjust-
ment in the system will remain active.
Light indication
The control lamp provides an indication on the
corresponding side regarding the traic situa-
tion behind the vehicle, if it is deemed to be
critical. The control lamp on the left-hand side
indicates the traic situation to the rear left of
the vehicle, and the control lamp on the right-
hand side indicates the traic situation to the
rear right of the vehicle .
Keep the warning lamps zone of the lane de-
parture warning free of objects, stickers or the
likes that may interfere with your visibility.
It lights up
It turns on once briey: the lane departure
warning is activated and ready to operate, i.e.
when activating the system.
It lights up continuously: the lane departure
warning has detected a vehicle in the blind
spot.
224
Assistant systems
Flashes
A vehicle has been detected in the adjacent
lane and the turn signal has been engaged in
the direction of the detected vehicle.
For vehicles that are also equipped with Lane
Assist ›››page215, a warning to switch lanes
will also appear even though the turn signal
has not been engaged (Lane Assist “Plus”).
The control lamps light up when the ignition is
switched on and should turn o after approxi-
mately 2 seconds. This is the time taken for the
function check.
If there are no indications from the control
lamp of the lane departure warning, this means
that the lane departure warning has not detec-
ted any other vehicles at the rear area.
When the exterior lighting is low, the intensity
with which the control lamps come on is dim-
med. The user can modify the intensity of the
control lamps with up to 5 levels in the infotain-
ment system menu.
Lane assist Plus.
The Lane Assist Plus function can be used by
activating the Lane Assist ›››page215 and
Side Assist functions. In this case its functions
are expanded as described below.
If the driver initiates a lane change manoeuvre
in a potential critical situation:
●
The lamp ashes in the corresponding rear-
view mirror even though the turn signal has not
been activated.
●
The steering wheel vibrates to warn the
driver of the risk of collision.
●
torque is applied to correct the steering and
return the vehicle to its lane.
Driving situations
Fig.146 Overtaking with traic behind the
vehicle.
Fig.147 Overtaking in the central lane and
then joining the right lane.
In the following situations, an indication will be
displayed by the control lamp ›››
Fig.144 ,
›››Fig.145 (arrow):
●
When being overtaken by another vehicle
›››Fig.146.
●
When overtaking another vehicle
›››Fig.147 with a speed dierence of approx.
10 km/h (6 mph). If the vehicle is passing at
a considerably higher speed, no indication will
be displayed.
The faster the vehicle approaches, the sooner
an indication will be displayed in the control
lamp, because the lane departure warning
takes into account the speed dierential with
other vehicles. Thus even though the distance
from the other vehicle is identical, the indica-
tion will appear sooner in some cases and later
in others.

Related Topics

Popular Owner Manuals