Advertisement

Advertisement

Starting And Operating -> E-Mode Selector for Your Fiat 500 E 4 Door Second Generation (2020-2024)

STARTING AND OPERATING 73  
Accelerator pedal released  
running or the propulsion system is active. Before  
exiting a vehicle, always come to a complete stop,  
then apply the park brake, shift the transmission  
into PARK, turn the ignition OFF, and remove the  
key fob. When the ignition is in the OFF mode, the  
transmission is locked in PARK, securing the vehicle  
against unwanted movement.  
WARNING!  
Driver's door open  
Do not coast in NEUTRAL and never turn off the  
ignition to coast down a hill. These are unsafe  
practices that limit your response to changing traffic  
or road conditions. You might lose control of the  
vehicle and have a collision.  
Car speed is below 3 km/h (2 mph).  
Operation with the ignition device to the OFF position  
The Auto Park function is activated when the  
transmission is in position D (Drive), N (Neutral) or R  
(Reverse), the car speed is less than 3 km/h and the  
user requests the car to be turned off by turning the  
ignition device to the OFF position.  
When leaving the vehicle, always remove the ignition  
key and lock your vehicle.  
CAUTION!  
Never leave children alone in a vehicle, or with  
access to an unlocked vehicle. Allowing children  
to be in a vehicle unattended is dangerous for  
a number of reasons. A child or others could  
be seriously or fatally injured. Children should be  
warned not to touch the parking brake, brake pedal  
or the transmission range buttons.  
Towing the vehicle, coasting, or driving for any other  
reason with the transmission in NEUTRAL can cause  
severe transmission damage. Refer to “Recreational  
Towing” in “Starting And Operating” and “Towing A  
Disabled Vehicle” in “In Case Of Emergency” for  
further information.  
Gear engagement inhibition  
This system prevents shifting the transmission from  
position P (Park) or N (Neutral) if the brake pedal has  
not been previously pressed. With ignition device in the  
ON/RUN position: the brake pedal must be pressed in  
order to shift the transmission from position P (Park) to  
positions R, N or D; to shift the transmission from  
position N (Neutral) to positions R or D the brake pedal  
must be pressed.  
4
Do not leave the ignition key in or near the vehicle  
(or in a location accessible to children). A child could  
operate power windows, other controls, or move the  
vehicle.  
D (Drive)  
Use this gear driving in towns and on motorways.  
Stopping the engine  
AUTO PARK  
R (Reverse)  
The system automatically engages P (Park) when the  
car is shut down (ignition device in OFF position).  
The function automatically put the transmission in P  
(Park) if there is any indication that the driver may  
leave the car while the transmission is in D (Drive), N  
(Neutral) or R (Reverse).  
The car can be moved backwards in this position.  
Select position R (Reverse) only with the car at a  
standstill.  
To stop the engine at speeds higher than 2.5 km/h hold  
the button of the ignition device pressed or press it  
three times in a row within a few seconds. The ignition  
device is in the ON/RUN position.  
Operation with the ignition device to the ON/RUN  
position  
N (Neutral)  
You can start the car with this gear engaged. Apply the  
parking brake and move the transmission to position P  
(Park) if you wish to exit the car.  
E-MODE SELECTOR  
The Auto Park function is activated when the  
transmission is in position D (Drive), N (Neutral) or R  
(Reverse) and the following conditions are detected:  
The E-Mode Selector is an “hold to operate” type which  
returns to the central position when released.  
Engagement of the required driving mode is indicated  
on the instrument panel display with a dedicated  
message.  
Seat belt not fastened  
Brake pedal released  
74 STARTING AND OPERATING  
NOTE:  
handling with a smoother response to accelerator pedal  
pressure. This mode helps to adopt a driving style  
aimed at maximizing the range.  
Refer to “Warning Lights And Messages” in “Getting To  
Know Your Instrument Panel” for further information.  
The system does not allow you to change the driving  
mode when you drastically reduce the performance  
of the electric motor.  
If the Electric Power Steering warning icon is displayed  
and the “Power Steering System Over Temp” message  
is displayed on the instrument cluster display, this  
indicates an over temperature condition in the power  
steering system. Once driving conditions are safe, pull  
over and let the vehicle idle for a few moments until the  
icon and message turn off.  
SHERPA Mode – In this mode the vehicle has  
no acceleration restriction but the top speed is  
electronically limited to 50 mph (80 km/h). This mode  
significantly helps to adopt a driving style aimed at  
maximum efficiency and maximizes the range of the  
vehicle. The climate control system and seat heaters  
are also automatically deactivated but can be manually  
reactivated if necessary.  
When the motor is started, the system usually  
maintains the driving mode that was active before  
the vehicle was stopped.  
The E-Mode Selector is located on the central console.  
NOTE:  
Even if the power steering assistance is no longer  
operational, it is still possible to steer the vehicle.  
Under these conditions there will be a substantial  
increase in steering effort, especially at low speeds  
and during parking maneuvers.  
POWER STEERING  
The electric power steering system will provide  
increased vehicle response and ease of  
maneuverability. The electric power steering system  
adapts to different driving conditions.  
If the condition persists, see an authorized dealer for  
service.  
WARNING!  
ACTIVE SPEED LIMITER  
The Active Speed Limiter button is positioned on the  
right side of the steering wheel.  
Continued operation with reduced assist could pose  
a safety risk to yourself and others. Service should be  
obtained as soon as possible.  
E-Mode Selector  
The E-Mode Selector consists of the following operating  
modes:  
Alternate electric power steering efforts can be selected  
through the Uconnect system. Refer to ”Customer  
Programmable Features” within “Uconnect Settings” in  
“Multimedia” for further information.  
NORMAL Mode – In this mode the vehicle has no  
performance limitations and can be driven fast using  
all the power and torque of the traction system. In this  
mode the energy consumption of the vehicle depends  
on the driving style.  
If the Electric Power Steering warning icon is  
displayed and the “Service Power Steering”  
or the “Power Steering Assist Off – Service  
RANGE Mode – In this mode the vehicle continues  
to have no speed restrictions but offers comfortable  
System” message is displayed within the  
instrument cluster display, this indicates the vehicle  
needs to be taken to an authorized dealer for service.