Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

Ease of use and comfort -> Interior fittings for Your Fiat Scudo Van Third Generation (2022-2025)

Ease of use and comfort  
To avoid any risk of jamming the pedals:  
– Only use mats which are suited to the  
fixings already present in the vehicle; these  
fixings must be used.  
Glove box  
It houses the front passenger airbag deactivation  
switch and can hold a bottle of water, the  
vehicle's handbook pack, etc.  
Interior fittings  
3
Mats  
– Never fit one mat on top of another.  
The use of mats not approved by Fiat may  
interfere with access to the pedals and hinder  
the operation of the cruise control/speed  
limiter.  
Fitting  
Never drive with the glove box (if  
equipped) open when a passenger is  
sitting at the front. It may cause injury during  
sharp deceleration.  
The approved mats have two fasteners  
located underneath the seat.  
Storage compartment  
This can hold a bottle of water, the vehicle's  
documentation, etc.  
In row 2 and row 3  
When fitting it on the driver's side, only use the  
mountings present on the carpet.  
The other mats are simply laid over the carpet.  
Removing/refitting  
To remove it on the driver's side, move  
the seat as far back as possible and give the  
fasteners a quarter turn.  
To open the storage compartment, press the  
left-hand end of the control and guide the lid to  
its open position notch.  
If your vehicle is so equipped, it is lit when the lid  
is opened.  
Use the Velcro straps to attach the transverse  
mat in row 2 with the longitudinal mats in rows  
2 and 3.  
To refit it, position the mat and replace the  
fasteners, giving them a quarter turn.  
► Check that the mat is secured correctly.  
When driving, keep the storage  
compartment closed. Otherwise, there is  
67  
Ease of use and comfort  
a risk of injury in the event of an accident or  
sudden braking.  
Any liquid which could spill risks causing  
an electrical short circuit and therefore a  
potential fire.  
For more information on the Front seats,  
and in particular placing the backrest in  
the "table" position, refer to the corresponding  
section.  
Front door storage pockets  
"Aircraft" type tables  
Liquids carried in an open vessel (e.g. a  
cup or mug) could be spilt, presenting a  
risk of damage on contact with the controls in  
the dashboard and centre console. Be  
careful.  
12 V socket(s)  
Depending on version.  
Fitted to the back of each front seat.  
Upper glove box  
This is located in the dashboard, behind the  
steering wheel.  
To use the table, lower it fully until it locks in  
the low position.  
To stow it, raise the table to the high position,  
passing the point of resistance.  
On the passenger side, do not forget to  
fold the table up before placing the seat  
in the "table" position.  
Do not place hard or heavy objects on  
the table. They could become dangerous  
projectiles in the event of emergency braking  
or impact.  
Press the control to open the lid (depending on  
version) then guide it to its fully open position.  
To close it, guide the lid then press the centre  
gently.  
68  
Ease of use and comfort  
For more information about how to use this  
equipment, refer to the sections describing  
the audio and telematics systems.  
USB socket  
3
220 V socket  
Depending on version, a 220 V/50 Hz socket  
(maximum power: 120 W) is located underneath  
the front right-hand seat and therefore  
accessible from row 2.  
This socket works with the engine running, as  
well as in STOP mode of Stop & Start.  
The socket can be used to connect a portable  
device or a USB memory stick.  
The socket reads audio files that are sent to your  
audio system to be played through the vehicle's  
speakers.  
These files can be managed using the steering-  
mounted controls or those on the audio system.  
The USB socket also allows a  
To connect a 12 V accessory (maximum  
power: 120 Watts), lift the cover and plug in a  
suitable adapter.  
Observe the maximum power rating to  
avoid damaging the accessory.  
The connection of an electrical device  
not approved by Fiat, such as a USB  
charger, may adversely affect the operation of  
vehicle electrical systems, causing faults such  
as poor radio reception or interference with  
displays in the screens.  
smartphone to be connected by  
Android Auto® or CarPlay®, enabling certain  
smartphone applications to be used on the touch  
screen.  
For best results, use a cable made or approved  
by the device manufacturer.  
These applications can be managed using the  
steering-mounted controls or the audio system  
controls.  
► Lift the cover.  
► Check that the indicator lamp is on green.  
► Connect your multimedia or other electrical  
device (telephone charger, laptop computer,  
CD-DVD player, bottle warmer, etc.).  
When the USB socket is used, the  
portable device charges automatically.  
While charging, a message is displayed if the  
power drawn by the portable device exceeds  
the current supplied by the vehicle.  
69