2023-2026 Hyundai Kona SUV Convenience Features -> Manual climate control system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Convenience Features -> Manual climate control system for Your Hyundai Kona SUV Second Generation (2023-2026)

Rear lamps  
Room lamp  
2C_RoomLamp  
:Press the button to turn on and off the rear room lamp.  
Vanity mirror lamp  
2C_SunvisorLamp  
Push the switch to turn the lamp on or off.  
: The lamp turns on if this button is pressed.  
: The lamp turns off if this button is pressed.  
Glove box lamp  
2C_GlobeBoxLamp  
Convenience Features 239  
The glove box lamp turns on when the glove box is opened.  
If the glove box is not closed, the lamp turns off after 20 minutes.  
NOTICE  
Close the glove box after use to prevent unnecessary battery discharge.  
Ambient light  
if equipped  
2C_MoodLamp  
[A] Driver seat door, passenger seat door  
[B] Passenger seat open tray  
To set the brightness and color of the ambient light, select Setup > Vehicle > Lights >  
Ambient Lighting in the infotainment system.  
• If the Link to Drive Mode is selected, the ambient light color changes according to the  
selected drive mode.  
• If you do not want to use ambient lighting, set Brightness to 0 in the infotainment  
system.  
Information  
• The infotainment system may change after software updates. For more information,  
refer to the manual provided in the infotainment system and the quick reference guide.  
• The color of the mood lamp may seem different under some conditions depending on  
the color of the interior and the set mood color.  
240 Convenience Features  
Cargo area lamp  
2C_LuggageRoomLamp  
The cargo area lamp turns on when the liftgate is opened and off when the liftgate is  
closed.  
NOTICE  
Close the liftgate after use to prevent unnecessary battery discharge.  
Convenience Features 241  
Wipers And Washers  
Front windshield wiper/washer  
2C_WiperSwitchOverview  
Rear windshield wiper/washer  
2C_WasherRearSwitchOverview  
A. Wiper speed control  
HI: High wiper speed.  
LO: Low wiper speed.  
INT: Intermittent wipe.  
AUTO(if equipped): Auto control wipe.  
OFF: Off  
MIST: Single wipe  
B. Intermittent or Auto control wipe time adjustment  
C. Wash with brief wipes (front)  
D. Rear wiper control  
HI: High wiper speed.  
LO: Low wiper speed.  
OFF: Off  
E. Wash with brief wipes (rear)  
242 Convenience Features  
Front windshield wipers  
Operates as follows when the engine is turned on.  
HI: The wiper runs at a higher speed.  
LO: The wiper runs at a lower speed.  
INT: Wiper operates intermittently at the same wiping intervals. To vary the speed  
setting, turn the speed control knob.  
OFF: Wipers are not in operation.  
MIST: For a single wiping cycle, push the lever downward and release. The wipers  
operate continuously if the lever is held in this position.  
Information  
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for  
about 10 minutes, or until the snow and/or ice is removed to prevent damage to the wiper  
and washer system.  
AUTO (Automatic) control  
if equipped  
2C_RainSensor  
The rain sensor located on the upper end of the windshield glass senses the amount of  
rainfall and controls the interval of the wiping cycle.  
To change the sensitivity setting, turn the sensitivity control knob.  
If the wiper switch is set in the AUTO mode when the Engine Start/Stop button is in the  
ON position, the wiper operates once to perform a self-check of the system. Set the wiper  
to the OFF position when the wiper is not used.  
WARNING  
To prevent personal injury:  
• Do not touch the upper end of the windshield glass facing the rain sensor.  
• Do not wipe the upper end of the windshield glass with a damp or wet cloth.  
• Do not put pressure on the windshield glass.  
Convenience Features 243  
NOTICE  
• When washing the vehicle, set the wiper switch in the OFF position to stop the auto  
wiper operation.  
• Do not remove the sensor cover located on the upper end of the passenger side  
windshield glass.  
Front windshield washers  
2C_WasherSwitch  
In the OFF position, pull the lever gently toward you to spray washer fluid on the  
windshield and to run the wipers 1-3 cycles. The spray and wiper operation continues  
until you release the lever. If the washer does not work, you may need to add washer fluid  
to the washer fluid reservoir.  
Recirculating air when washer fluid is used  
When washer fluid is used, in order to reduce any objectionable scent of the washer  
fluid from entering the cabin, recirculation mode and air conditioning are automatically  
activated depending on the outside temperature. If you select fresh mode while the  
function is operating, the function resumes after a certain amount of time. It may not  
work in some conditions such as cold weather or vehicle OFF.  
For more information, refer to the “Climate control additional features” section in this  
chapter.  
WARNING  
When the outside temperature is below freezing, always warm the windshield using the  
defroster to help prevent the washer fluid from freezing on the windshield and obscuring  
your vision that could lead to a collision resulting in serious injury or death.  
Always use appropriate washer fluids in the winter season or cold weather.  
244 Convenience Features  
NOTICE  
To prevent damage:  
• Do not operate the washer when the fluid reservoir is empty or when the windshield is  
dry.  
• Do not operate the wipers when the windshield is dry.  
• Do not attempt to move the wipers manually.  
• Use anti-freezing washer fluids in the winter season or cold weather.  
Rear windshield wipers and washers  
2C_WiperRearOperation  
The rear window wiper and washer switch is located at the end of the wiper and washer  
switch lever. Turn the switch to the desired position to operate the rear wiper and washer.  
HI: High wiper speed  
LO: Low wiper speed  
OFF: Off  
Auto rear wiper  
2C_WasherRearSwitch  
Push the lever away from you to spray rear washer fluid and to run the rear wipers 1-3  
cycles. The spray and wiper operation continues until you release the lever.  
• The rear wiper operates while the vehicle is in reverse with the front wiper on. You can  
select the function from the Settings menu in the infotainment system. Select:  
Setup > Vehicle > Convenience > Auto Rear Wiper (in R)  
Convenience Features 245  
For more information, refer to the “Recirculating air when washer fluid is used” section  
in chapter 5.  
246 Convenience Features  
Manual Climate Control System  
if equipped  
1C_Aircon_2  
1. Fan speed control  
2. Temperature control  
3. Mode selection  
4. Front windshield defroster  
5. A/C (air conditioning)  
6. Air intake control  
7. Rear window defroster  
Heating and air conditioning  
1
Start the engine.  
2 Set the mode to the desired position.  
To improve the effectiveness of heating and cooling, select:  
• Heating:  
• Cooling:  
3 Set the temperature control to the desired position.  
4 Set the air intake control to the outside (fresh) air position.  
5 Set the fan speed control to the desired speed.  
If air conditioning is desired, turn on the air conditioning system.  
Mode selection  
The mode selection knob controls the direction of the air flow through the ventilation  
system.  
Convenience Features 247  

Related Topics

Popular Owner Manuals