To defrost outside windshield
2C_InsideDefrostProcedure_2
1. Set the fan speed to the highest position.
2. Set the temperature to the hottest (HI) position.
3. Press the defroster button (
)
4. The air conditioning turns on according to the detected ambient temperature and the
outside (fresh) air mode is selected automatically.
If the defrost switch is selected, lower fan speed is adjusted to higher fan speed.
Defogging logic
To reduce the probability of fogging up the inside of the windshield, the air intake or air
conditioning are controlled automatically according to certain conditions. To cancel or
reset the defogging logic, do the following.
1
Press the Engine Start/Stop button to the ON position.
2 Press the defroster button ( ) or ( ).
3 While pressing the air conditioning button, press the air intake control button at least 5
times within 3 seconds
The air intake control button indicator blinks 3 times to indicate that the defogging logic
has been disabled. Repeat the steps again to re-enable the defogging logic.
If the battery has been discharged or disconnected, it resets to the defog logic status
Rear window defroster
NOTICE
Never use sharp instruments or window cleaners containing abrasives to clean the
window to prevent damage to the rear window defroster.
The defroster heats the window to remove frost, fog and thin ice from the interior and
exterior of the rear window, while the engine is running.
Convenience Features 269
English 
